For sign flag , Electrical Engineering

Assignment Help:

For Sign Flag

 CP ( Call on plus ) CM (Call on minus ) Instruction

CP call  the subroutine  from the  specified  memory  location if  sign flag is not set or reset( S=0). The instruction  format is

                             CP 16 bit   memory  address

CM call the   subroutine  from the specified memory location if sign flag is set (S=1).  The instruction  forma is

                            CM 16 bit  memory address

 


Related Discussions:- For sign flag

Analyse the characteristics of a dc machine, Theoretical calculations T...

Theoretical calculations The characteristics of the d.c. machine you will be investigating are given on the last page of this part. Use 200V DC supply for both armature and fie

Find magnitude and direction developed torque, Q. The self and mutual induc...

Q. The self and mutual inductances of a machine with two windings are given by L 11 = (1 +sin θ), L 22 = 2(1 + sin θ), and L 12 = L 21 = M = (1-sin θ). Assuming θ = 45°, and le

Network analysis software, Network analysis software: GIS with a socke...

Network analysis software: GIS with a socket for network analysis software (Sec. 11.4) and availability of load related data from AMR based meter data acquisition system will

National tariff policy or ntp, National Tariff Policy or NTP In the dr...

National Tariff Policy or NTP In the draft of NTP, it is suggested that although setting the tariff ERC should introduce performance-based cost of service regulations, a clear

#DSP ., #The requirement is as follows- There is a signal which is in the r...

#The requirement is as follows- There is a signal which is in the range of 0 to 5Hz. This signal frequency composition is to determined. The resolution of the determination is 1Hz.

What is capacitance, What is Capacitance -  Capacitance is explained to...

What is Capacitance -  Capacitance is explained to be the amount of charge Q stored in among the two plates for a potential difference or voltage V existing across the plates.

Explain the construction of jfet, Q. Explain the construction of JFET? ...

Q. Explain the construction of JFET? The basic construction of the p-channel JFET is shown in figure. The major part of the structure is the p-type material that forms the chan

Balanced delta-connected load, Q. A balanced delta-connected load with a pe...

Q. A balanced delta-connected load with a per-phase impedance of 12 + j9  is supplied by a 173-V, 60-Hz three-phase source. (a) Determine the line current, the power factor, th

Measurement, Why delay circuit used in CRO?

Why delay circuit used in CRO?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd