For carry flag - return instructions , Electrical Engineering

Assignment Help:

For Carry Flag

 RC (Return of Carry) and RNC ( Return on no Carry) Instruction

RC returns from  the subroutine  to the calling  program if carry  flag is et (CY= 1). The instruction format is

                             RC

RNC Return from the subroutine to the calling program if carry flag is not set ( CY= 0). The instruction format is

                            RNC


Related Discussions:- For carry flag - return instructions

Passive filters, Passive filters: Passive implementations of linear fi...

Passive filters: Passive implementations of linear filters are based upon combinations of inductors (L), resistors (R), and capacitors (C). These sorts are collectively termed

Obtain the complete solution for the voltage, Consider the circuit of Figur...

Consider the circuit of Figure and obtain the complete solution for the voltage v C (t) across the 5-F capacitor and the voltage vx(t) across the 5- resistor.

Determine the analog output voltage, Q. Analyze the 2-bit R-2R ladder-netwo...

Q. Analyze the 2-bit R-2R ladder-network D/A converter, and corresponding to binary 01, 10, and 11, obtain the equivalent circuits and determine the analog output voltage as a frac

Discuss description of insulating materials, Discuss description of insulat...

Discuss description of insulating materials on the basis of physical and chemical structure Insulating materials, on the basis of their physical and chemical structure may be d

Chemistry, Write short note on hardness of water and its units

Write short note on hardness of water and its units

Find the thevenin equivalent of the circuit, (a) Find the Thevenin equivale...

(a) Find the Thevenin equivalent of the circuit shown in Figure (a) at the terminals A-B. (b) Determine the impedance that must be connected to the terminals A-B so that it is m

The three-phase alternator, The Three-phase alternator In this case, t...

The Three-phase alternator In this case, three separate sets of coils are wound on the stator and connected to produce three separate outputs. Because of the physical displace

Determine the induced voltage at full load, A 100-kW, 250-V shunt generator...

A 100-kW, 250-V shunt generator has an armature-circuit resistance of 0.05  and a field- circuit resistance of 60 . With the generator operating at rated voltage, determine the i

Describe the operation of 8279, Q. Describe the operation of 8279. And als...

Q. Describe the operation of 8279. And also explain following terms: (i) N key Roll over. (ii) Key board debounce. (iii) FIFO RAM. Ans: 8279 is a programmabl

Illustrate the experts model of GPS system, Illustrate the experts model of...

Illustrate the experts model of GPS System A fundamental expert system is made up of the below elements: Setting up an Expert System -  Information is collected

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd