Find the sending end voltage and sending end current, Electrical Engineering

Assignment Help:

A 3-phase transmission line is 200km long. The line has a per phase series impedance of 0.25+j0.45 Ω/km and shunt admittance of j7.2 μS/km. The line delivers 250MVA, at 0.6 lagging power factor and 120V to a 3-phase load.

a)  Determine ABCD parameters of the line.

b)  Find the sending end voltage, sending end current, voltage regulation and the efficiency of the line.

c)  Determine the capacitance per-phase of the Y-connected capacitors to adjust the power factor of the load to unity and calculate the voltage regulation and the line efficiency in this case.


Related Discussions:- Find the sending end voltage and sending end current

Digital switching switching in telecommunication, Name the switching scheme...

Name the switching schemes used in a digital exchange

Determine the stations visual-carrier frequency, If a television station op...

If a television station operates on UHF channel 20 (band 506-512 MHz), determine the station's visual-carrier frequency.

Emitter follwer, Ask questertion #Minimum 100 words accepted#

Ask questertion #Minimum 100 words accepted#

Explain working of biased clamper, Q. Explain working of Biased Clamper? ...

Q. Explain working of Biased Clamper? Biased Clamper : The circuit of a positively biased clamper is shown in the figure. During the negative half cycle of the input signal the

Explain lithography, Explain Lithography. Lithography - This is one ...

Explain Lithography. Lithography - This is one of the processes which is carried out throughout manufacture of integrated circuits. Silica oxide (SiO 2 ) layer is thermally

Power distribution, Determine the current through each parallel branch of t...

Determine the current through each parallel branch of the system

List few applications of microprocessor-based system, List few applications...

List few applications of microprocessor-based system. It is used: i. For measurements, display and control of current, voltage, temperature, pressure, etc. ii. For traff

Circuit theorems, limitations and applications of following circuit theorem...

limitations and applications of following circuit theorems: telleans theorem superposition theorem norton theorem compensation theorem millman theorem reciprocity theorem maximum p

Phase lead controller design and digital implementation, The arm of a hydra...

The arm of a hydraulic robot is controlled as shown in the block diagram below: The arm dynamics are represented by: Dynamic specification for the arm requires:

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd