Find the maximum kva rating as an auto- transformer, Electrical Engineering

Assignment Help:

Q. A 5-kVA, 480:120-V, two-winding, 60-Hz, single-phase transformer has an efficiency of 95% while delivering rated load at rated voltage and 0.8 power factor lagging. This transformer is to be connected as an autotransformer to step down a 600-V source to 480 V.

(a) Draw a schematic connection diagram as an autotransformer.

(b) Find the maximum kVA rating as an auto- transformer.

(c) Compute the efficiency as an autotrans- former delivering its rated kVA at 480 V and 0.8 power factor lagging.


Related Discussions:- Find the maximum kva rating as an auto- transformer

What is a bode plot and what are i''s uses, Q. (i) What are the different t...

Q. (i) What are the different types of plots for frequency response in an RC coupled amplifier?     (ii) What is a Bode Plot? What are it's uses? The different types of

Torque-Speed Characteristics of 3-Phase Induction Motors, Torque-Speed Char...

Torque-Speed Characteristics of 3-Phase Induction Motors

Explain a miller sweep generator, Q. With the help of circuit diagram expla...

Q. With the help of circuit diagram explain a Miller Sweep generator Figure given below shows the circuit of a Miller integrator or a sweep circuit. Transistor Q1 acts as a swi

Cmos integrated circuit design, design using softwares (LEdit7, LTspice) t...

design using softwares (LEdit7, LTspice) the project has many aspects and I would like you to check them on the website with my personal password. in the project specifications (d

Determine the stresses set up in the cylinder and steel wire, A copper cyli...

A copper cylinder 40 cm diameter and 10 mm thick is nearly wound with a layer of 4mm diameter steel wire under a tensile stress of 80 Mpa. If the steam under a pressure of 5 Mpa is

Describe small signal fet and its characteristics, Q. Describe small signal...

Q. Describe small signal FET.What are its characteristics? Small signal FET is the FETs used for amplification. The linear characteristic of FET is used for this purpose The in

SOLID MENSURATION, the base of isosceles triangle and the altitude drawn fr...

the base of isosceles triangle and the altitude drawn from one of the congruent sides are equal to 18cm and 15cm, respectively. Find the lengths of the sides of the triangle.

Sonic harassment, Sir I would like to find a sensor that can detect beams ...

Sir I would like to find a sensor that can detect beams from the phasor painfield generator and the sonic devasator (devices of this nature). These sonic devices emit a high pres

What are the steps concerned to fetch a byte in 8085, What are the Steps co...

What are the Steps concerned to fetch a byte in 8085 The PC places the 16-bit memory address on the address bus The control unit sends the control signal RD to enable

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd