Final Problem, Physics

Assignment Help:
A 1.6 kg man swings from a 2 meter rope at an angle of 45 degrees after swinging 20 degrees past the center point, the rope is cut by a razor.

The man goes flying through the air, where should we put a car so he lands in it?

The cart is 4.5 Kg, when the man lands in it how far will the cart and man roll if there is a friction coefficient of .08.

Related Discussions:- Final Problem

Rate of effusion of nitrogen gas, How can we calculate the rate of effusion...

How can we calculate the rate of effusion of nitrogen gas from a cylinder. and how much time it will take??

What can justify the use of fiber optic, What can justify the use of fiber ...

What can justify the use of fiber optic? In the huge majority of tasks, using traditional implies, the amount of light used is far in excess to the quantity really required. Mo

Evalaute the final temperature, Helium gas with a volume of 2.60 L, under a...

Helium gas with a volume of 2.60 L, under a pressure of 1.30atm and at a temperature of 41.0 degrees, is warmed until both pressure and volume are doubled. a)What is the final temp

Historical development of atomic models, Historical development of atomic m...

Historical development of atomic models In olden days there was an idea that all matter is made of tiny indivisible particles. When Thomson discovered electron, this idea

Kinetic energy, Why is the Kinetic energy of the system minimum in the fram...

Why is the Kinetic energy of the system minimum in the frame of the center of mass for any number of particles solution) The kinetic energy of any entity depends on the reference

Superconducting transition temperature, Q. What are the changes that take p...

Q. What are the changes that take place at the superconducting transition temperature? At the transition temperature the subsequent changes are observed (i) The electrical res

Newton''s ring, in newton''s rings experiment the diameter of the nth and n...

in newton''s rings experiment the diameter of the nth and n+14 rings are 3.2mm and 6mm respectively.Radius of curvature of plano convex lens is 1m.Calculate wavelength of light.

Forces, what is the difference between pulling and pushing forces

what is the difference between pulling and pushing forces

Determine the maximum load, The cable will fail when the tension is P54 kN....

The cable will fail when the tension is P54 kN. For a Factor of Safety of 1.5 for the cable, determine the largest vertical load P that the frame will support, and then for that lo

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd