Explain working of steam sampling, Mechanical Engineering

Assignment Help:

Q. Explain working of Steam Sampling?

Sample coolers shall be supplied by the Vendor. A common sample spillage trough shall also be provided by the Vendor, with a cover screen and a 2"NPS flanged drain connection for connection to Purchaser's drain system.


Related Discussions:- Explain working of steam sampling

Slip of belt, Slip of belt: Sol:   When the driver pulley rotates, it...

Slip of belt: Sol:   When the driver pulley rotates, it carries belt, because of a firm grip between its surface and belt. The firm between pulley and belt can be obtained by

Newton''s law of motion - first law, Newton's law of motion. Sol.: T...

Newton's law of motion. Sol.: The entire system of Dynamics is based on the three laws of motion that are basis assumptions, and were initially formulated by Newton. Fir

Optimization, consider the following LPP max z=9x1+8x2+5x3 subject to 2x1+3...

consider the following LPP max z=9x1+8x2+5x3 subject to 2x1+3x2+x3 5x1+4x2+3x3 x1,x2,x3>_0 (a)solve using simlex method (b)hence using the sesitivity analysis

Taking care of occupational safety, Taking Care of Occupational Safety ...

Taking Care of Occupational Safety The most important development in occupational safety and health has been the introduction of legislative measures adopted by various gover

Degree of super heat - thermodynamics, Degre e of Super Heat: It is d...

Degre e of Super Heat: It is difference between the temperature of superheated steam and saturation temperature resultant to the given pressure. So, the degree of superhea

Determine the centroid of the area, Determine the centroid of the area: ...

Determine the centroid of the area: Determine the centroid of the area OBDC Solution The trapezium area is divided in two simple areas,  (i)        A 1 = Rectangle

Determine the thermal conductivity of the rod, One end of a rod, 35 mm in d...

One end of a rod, 35 mm in diameter, is diped into a furnace with the other end projecting in the outer air. After the steady state is obtained, the temperature of the rod is evalu

Why we use nickel alloys in welding, Q. Why we use Nickel Alloys in welding...

Q. Why we use Nickel Alloys in welding? Nickel weld metals have high creep-rupture strength but often have lower stress-rupture ductility and lower mechanical and thermal fatig

Arc strikes-metallurgical defects, Arc strikes Represent any localised ...

Arc strikes Represent any localised heat affected zone caused by an arc. Arc strike tends to produce hardening particularly in high carbon steels and alloy steels. Grinding of

Metallurgical defects-gas porosity, Gas Porosity Porosity is the...

Gas Porosity Porosity is the presence of gas pockets or voids caused by the entrapment of gas evolved during weld metal solidification. This Porosity is caused due to im

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd