Explain the technique- backpressure, Computer Networking

Assignment Help:

Explain the technique- Backpressure

This technique produces an effect same to backpressure in fluids flowing down a pipe. It includes link-by-link use of flow control in a direction toward the source.

 


Related Discussions:- Explain the technique- backpressure

When would we use isdn, We use IDSN supports high speed voice, data and vid...

We use IDSN supports high speed voice, data and video and is a good choice for many small businesses.

Explain in brief about crc, What is CRC The CRC is computed while trans...

What is CRC The CRC is computed while transmission and appended to output stream as soon as last bit goes out onto wire. If the CRC were in header, it will be necessary to make

What is the catalogue intranet, What is the Catalogue Intranet Intra...

What is the Catalogue Intranet Intranets of this type are often more accurately described as Extranets. They are designed to give access to a large catalogue of information,

Determine the signal bandwidth and the amplitudes, 1. A low voltage digital...

1. A low voltage digital device has a low state of 0 V and a high state of 1.8 V. It generates a signal train of high pulses at a rate of 1 MHz, these pulses having a 10 ns width a

Name the layers of osi, List the layers of OSI There are seven layers i...

List the layers of OSI There are seven layers in OSI model a. Physical Layer b. Data Link Layer c. Network Layer d. Transport Layer e. Session Layer f. Presen

Illustrate TCP – bytes and segments, Q. Illustrate TCP – bytes and segments...

Q. Illustrate TCP – bytes and segments? TCP - bytes & segments TCP at the sending site collects bytes into a packet called a segment TCP adds a header to each se

Error correction - retransmission, When an error is discovered the receiver...

When an error is discovered the receiver is able to ask the sender to retransmit the entire data unit Error Correction-Forward Error Correction A receiver is able to u

Configure the physical topology- ccna, Configure the Physical Topology ...

Configure the Physical Topology Step 1: Cable the network. Refer to the figure and table below for the essential cables. Step 2: Physically connect lab devices. C

Which layer is responsible for framing, The Data link layer performs the fo...

The Data link layer performs the following: Responsible for physically passing data from single node to another. Translates messages from the upper layers into data frames and adds

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd