Explain the newer machining processes, Mechanical Engineering

Assignment Help:

Explain the Newer Machining Processes

In recent years a number of new material have been developed which are being commonly used in space research missiles and nuclear industry.
These materials are stronger, harder, tougher, heat and wear resistant and cannot be machined by this conventional machining process.
These difficulties of conventional machining process are solved by this process.
It is new metal removing process called newer machining process or unconventional machining process.
This processes are widely used for

1. Producing complex surfaces effectively and efficiently.

2. Producing very high surface qualities.

Related Discussions:- Explain the newer machining processes

What could be the characteristics of tool materials, (a) What could be the ...

(a) What could be the characteristics of tool materials. (b) Describe several tool materials with their composition.

Manufacturing scince, advantages and disadvantages of hot working

advantages and disadvantages of hot working

What are the reasons behind poor pick-up of motor cycle, (a) Why does engin...

(a) Why does engine overheat and what will happen if engine overheats? (b) Why engine does not start in wet or damp weather? (c) What may be the causes if engine dose not sta

Explain the hydraulically extendible, Explain the Hydraulically extendible ...

Explain the Hydraulically extendible Most paver manufacturers have developed hydraulically extendable paver screeds hat trail the primary or basic screed on the paver. One make

Explain hard or fixed automation, Explain Hard or Fixed Automation Mech...

Explain Hard or Fixed Automation Mechanical controls consist of numbers of mechanism that create the required relative motion to complete an activity. These mechanisms include:

Inlet manifold-basic components of engine , Inlet Manifold: The pipe whic...

Inlet Manifold: The pipe which connects the intake system to the inlet valve of the engine through which air or air-fuel mixture is drawn into the cylinder is called the inlet ma

Prototyping methods of advance manufacturing, The three prototyping method...

The three prototyping methods used are: a) R a p i dPrototyping: This is used to model the pins (large 1, 2 and small), lock disk and crank. b) CNCMachining: Use

Explain gated pattern, Gated pattern This is an improvement over the si...

Gated pattern This is an improvement over the simple pattern where the gating and runner system are integral with the pattern. This would eliminate the hand cutting of the runn

Application of hot service insulation, Q. Application of hot service insula...

Q. Application of hot service insulation? Provision for the expansion of hot equipment shall include the installation of expansion springs in circumferential banding securing i

Co-efficient of thermal conductivity, State required Features of Fourier La...

State required Features of Fourier Law. What are the factors on which co-efficient of thermal conductivity (K) depends upon ? Write the unit of K.

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages