Explain the methods of underwater inspection, Civil Engineering

Assignment Help:

Explain the Methods of Underwater Inspection?

There are three common methods of carrying out underwater inspection of bridge elements.

a) Wading inspection

b) Scuba diving

c) Surface supplied air diving

Related Discussions:- Explain the methods of underwater inspection

State the net allowable bearing pressure, A footing, 2 m square, is founded...

A footing, 2 m square, is founded at a depth of 1.5 m in a sand deposit, for which the corrected value of N is 27. The water table is at a depth of 2 m from the surface. Verify the

Calculate the annual cost of alum - coagulation, Incoming water contains 2....

Incoming water contains 2.5 mg/L as a substance of natural alkalinity (HCO 3 - ). The flow rate is 9.5 ML/day). (a) What feed rate is required if the alum dose is 7 mg/L and

Minor losses using th method of loss coefficients, Minor Losses Using Th Me...

Minor Losses Using Th Method of Loss Coefficients One method of calculating the energy loss as a result of fluid flowing through a device or fitting, each device or fitting has

Concrete technology, what is the actual quantity of water to be mixed in va...

what is the actual quantity of water to be mixed in various grade of concrete and also the size of gravel to be mixed with in RCC work. Also I want to know the difference between a

Logarithmic decrement, expain

expain

Soil particles for geotechnical design, Question Will it worthwhile to ...

Question Will it worthwhile to take out tests on particle density of soil particles for geotechnical design? Answer Particle density of soils is definite by ratio of

Determine the northing and easting coordinates, The northing and easting co...

The northing and easting coordinates for point C is most nearly: Solution: Section the triangle and calculate using Pythagorean Theorem and the Law of Sine's or us

Calculate the parameters for setting out curve, Q For a curve of 50, apex ...

Q For a curve of 50, apex angle of 900 and transition length of 60m, calculate the parameters for setting out curve by a Theodolite for TTP, mid point of transition, CTP and a p

Define the types of sedimentation, Define the Types of Sedimentation 1....

Define the Types of Sedimentation 1. Type I Particles that settle discretely (settle as individual particles) sand, grit Pre-sedimentation for sand prior to co

Calculate the percent change in load on the wall form tie, A concrete wall ...

A concrete wall form tie with an ultimate strength capacity of 2,400-lbs is designed for use in a concrete wall form with an 18-in center to center spacing. During formwork inspect

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages