Explain the external data bus, Electrical Engineering

Assignment Help:

Q. Explain the External Data Bus?

External Data Bus: A bus which connects a computer to peripheral devices. 8088 microprocessor has 16-bit registers, 16-bit internal data bus in addition to the 20-bit address bus that allows processor address up to 1 MB of memory.


Related Discussions:- Explain the external data bus

Operation of a biased clipper and combination clipper, Q What is a clipper?...

Q What is a clipper? Describe the operation of a biased clipper and combination clipper. The circuit with which the waveform is shaped by removing (or clipping) a portion of th

Assembly language programming , Assembly Language Programming  In this...

Assembly Language Programming  In this   chapter  we will   discuss  programming  in assembly  language and  machine  language. The  difference  in machine  assembly  and high

Ac motors, If the stator windings of an alternator were to be supplied ...

If the stator windings of an alternator were to be supplied by an AC of frequency f (as opposed to drawing an AC current from them as would be the case for an alternator) then

What is elementary diode circuits, Q. What is Elementary Diode Circuits? ...

Q. What is Elementary Diode Circuits? Semiconductor diodes are used in a wide variety of applications. Their usage abounds in communication systems (limiters, gates, clippers,

Electrical and electronic principles, 12. A capacitor is to be constructed ...

12. A capacitor is to be constructed so that its capacitance is 0.2µF and to take a p.d. of 1.25kV across its terminals. The dielectric is to be mica which, after allowing a safety

Determine the steady state position error, Figure shows the block diagram o...

Figure shows the block diagram of an aircraft pitch stabilization system which uses position, velocity and acceleration feedback. i) Show that for a unit step input the steady s

Calculate the maximum power that transmitted to the load, Calculate the Max...

Calculate the Maximum Power That Transmitted To the Load? A 25 MW load at the 33 kV receiving-end busbar of a short 3-phase transmission line has a power factor of 0.8 lagging.

Determine the stresses set up in the cylinder and steel wire, A copper cyli...

A copper cylinder 40 cm diameter and 10 mm thick is nearly wound with a layer of 4mm diameter steel wire under a tensile stress of 80 Mpa. If the steam under a pressure of 5 Mpa is

Which stack is used in 8085, LIFO (Last In First Out) stack is used in 8085...

LIFO (Last In First Out) stack is used in 8085.In this type of Stack the last kept information can be retrieved first.

Pre-processing requirements - cpld design project , The pre-processing unit...

The pre-processing unit is responsible for taking the conditioned output from the heart sensor and generating a binary count during time T1 of this waveform (datain). It will compr

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd