Explain bus topology, Computer Networking

Assignment Help:

Explain Bus Topology.

The physical Bus topology is the easiest and most widely used of the network designs. It having of one continuous length of cable (trunk) and a terminating resistor (terminator) at each end. Data communication message travels with the bus in both directions until it is picked up by a workstation or server NIC. If the message is missed or not recognized, it reaches the end of the cabling and dissipates at the terminator.

 


Related Discussions:- Explain bus topology

What is stop-and-wait automatic repeat request, What is Stop-and-Wait Autom...

What is Stop-and-Wait Automatic Repeat Request? Error correction in Stop-and-Wait ARQ is implemented by keeping a copy of the sent frame and retransmitting of the frame when th

Hybrid networks -v irtual private networks , Hybrid Networks Allows  a...

Hybrid Networks Allows  an organization to have its  own  private networks  and at the same  time access to the global internet. the organization  may share  its information w

Running netware 4.11 and you cant commune with your router, You are a syst...

You are a system administrator on a NetWare network, you are running  NetWare 4.11 and you cannot commune with your router. What do think what problem is? Ans)NetWare 4.11 defau

Types of wires, TYPES OF WIRES:  Cable used for wiring would match the...

TYPES OF WIRES:  Cable used for wiring would match the following: The intended speed The distance between computers The amount of noise Anticipated future r

Which two commands shows the cisco ios filename, These two command show the...

These two command show the cisco IOS filename a) show ver b) show flash

Install, how to install xp via network

how to install xp via network

Determine sonet devices, Sonet Devices STS Mux or DMux either multiplex...

Sonet Devices STS Mux or DMux either multiplexes signals from multiple sources into an STS or demultiplexes an STS into different destination signals. Regenerator is a repea

Repeaters, REPEATERS:  Repeaters are needed when copper wire communica...

REPEATERS:  Repeaters are needed when copper wire communication is takes place. According to the fact that electrical signal goes weaker while travelling over copper lines. A

Determine the window positions for succession of events, Two neighbouring n...

Two neighbouring nodes (A and B) use a Go-Back-N protocol with a 3-bit sequence number and a window size of 4. Acknowledgments are cumulative. Assuming A is transmitting and B is r

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd