Explain bios, Electrical Engineering

Assignment Help:

Explain BIOS

The IBM PC has in its ROM a collection of routines, each of which performs some particular function such as reading a character from keyboard, writing character to CRT. This collection of routines is referred to as Basic Input Output System or BIOS.

 


Related Discussions:- Explain bios

Common drain amplifier, Common Drain Amplifier In electronics, a comm...

Common Drain Amplifier In electronics, a common-drain amplifier, as well termed as a source follower, is one type of three basic single-stage field effect transistor (FET) am

Split-phase or resistance-split-phasemotor, Q. Split-phase or resistance-sp...

Q. Split-phase or resistance-split-phasemotor? Split-phase or resistance-split-phasemotors: Split-phasemotors have two statorwindings (amainwinding and an auxiliarywinding)with

What do you understand by orthographic projection, What do you understand b...

What do you understand by orthographic projection ? Illustrate with the help of Matrix representation.

Characteristics of magnetic field / flux lines, Characteristics of magnetic...

Characteristics of magnetic field / flux lines: i.  Forming a closing loop ii. Did not crossed against each other iii. Has a certain direction iv. Repel among one anot

Frequency Variation, Frequency variation in simple transmitters can be redu...

Frequency variation in simple transmitters can be reduced by adding a _______ stage.

Give the operating modes of 8259a, Give the operating modes of 8259a? (...

Give the operating modes of 8259a? (a) Automatic Rotation (b) End of Interrupt (EOI) (c) Fully Nested Mode  (d) Automatic EOI Mode (e) Specific Rotation (f) Edge

Mode 2 - boost converter, Mode 2 In this  mode transistor  gets turne...

Mode 2 In this  mode transistor  gets turned off by  the negative output  of PWM  current  flows  through  inductance L diode D then  divide into two  parts one flows through

ADC and DAC design, I''m trying to design ADC using MAX1198 and DAC using I...

I''m trying to design ADC using MAX1198 and DAC using IDAC in Multisim 12 but none of them are working. I need some help in this regard

Evaluate supply and the supply power factor, Q. Two balanced, three-phase, ...

Q. Two balanced, three-phase, wye-connected loads are in parallel across a balanced three-phase supply. Load 1 draws a current of 20 A at 0.8 power factor leading, and load 2 draws

Explain state-variable techniques, Q. Explain state-variable techniques? ...

Q. Explain state-variable techniques? The matrix formulations associated with state-variable techniques have largely replaced the block-diagram formulations. Computer software

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd