Explain about flow control, Computer Networking

Assignment Help:

Q. Explain about Flow Control?

- Signifies to ask the transmitter to stop/resume sending in data

- Required when

  • DTE to DCE speed > DCE to DCE speed

- (Example terminal speed = 115.2kbps and line speed = 33.6kbps in order to benefit from modem's data compression protocol)

  • Without flow control, the buffer within modem will overflow - sooner or later

- The receiving end take time to procedure the data and thus cannot be always ready to receive


Related Discussions:- Explain about flow control

Concept of connection between the pc and the cable modem, Concept of connec...

Concept of connection between the PC and the cable modem Even if downstream channel works at 27 Mbps, user interface is nearly always 10-Mbps Ethernet. There is no way to get b

Explain about wireless ethernet, Wireless Ethernet (802.11) a) Operates...

Wireless Ethernet (802.11) a) Operates on physical plus data link layers b) BSS (Basic service set) stationary or mobile wireless stations and a central base station known a

Describe ethernet, Describe Ethernet. Ethernet is one of the well-liked...

Describe Ethernet. Ethernet is one of the well-liked networking technologies used these days. It was developed during the early 1970s and is based on specifications as stated i

Sequence number - transport layer, Sequence Number After  the bytes...

Sequence Number After  the bytes have been numbered TCP assigns a sequence number to each segment   that is  being sent. These sequence number for each segment  is the numb

Packet loss and retransmission in tcp, Packet loss and retransmission in TC...

Packet loss and retransmission in TCP TCP gets reliability by retransmission. An acknowledgement is used to check that data has arrived successfully. If acknowledgement does no

Ipv6 packet format - network layer and routing , IPv6 packet Format Th...

IPv6 packet Format The format  of an IPv6 header is shown  in figure. Although IPv6 addresses are four  times  the size  of IPv4 address  the basic  IPv6 header is only twice

What is the use of a default gateway, What is the use of a default gateway?...

What is the use of a default gateway? Default gateways give means for the local networks to connect to the external network. The default gateway for connecting to the external

How to perform basic switch configurations-ccna, How to Perform Basic Switc...

How to Perform Basic Switch Configurations Step : Complete basic configuration of switches S1, S2, and S3. Configure the S1, S2, and S3 switches according to the following

Introduction-parallel algorithms, Introduction An algorithm is defined ...

Introduction An algorithm is defined as a series of computational steps required to accomplish an exact task. The algorithm works for a given input and will terminate in a well

Switching via an interconnection network, Switching  via an interconnectio...

Switching  via an interconnection network The switching  techniques  overcome the bandwidth  limitation of a single  shared bus. This technique use a more sophisticated interco

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd