Explain aas instructions in 8086 family, Electrical Engineering

Assignment Help:

Explain AAS instructions in 8086 family with example and their effect on flag.

AAS: it is stands for ASCII adjust after subtraction; this is used to adjust the AX register later than a subtraction operation.


Related Discussions:- Explain aas instructions in 8086 family

Microcontroller, What are usue and all the details of 8051 microcontroller ...

What are usue and all the details of 8051 microcontroller with its block diagram pin diagram and all other details

Show cmos logic families, Both DTL and TTL are based on the saturating BJT ...

Both DTL and TTL are based on the saturating BJT inverter. The transistor acts as a switch that connects or disconnects the collector and emitter. The switch is closed when suffici

What is expanded memory system, What is expanded memory system? EMS: Th...

What is expanded memory system? EMS: The area at location C8000H-DFFFFFH is frequently open or free. Such area is used for the expanded memory system into a XT or PC system, or

What is the use of latch signal on the ad0-ad15 bus, What is the  use of l...

What is the  use of latch signal on the AD0-AD15 bus in an 8086 system? Latch signal is used to load the data those are fetched from memory to bus.

Determine the three main types of intelsat satellite, a. Determine the rati...

a. Determine the ratio of cross section of a circular waveguide to that of a rectangular one, if each is to have similar cut off wavelength for its dominant mode. b. Compare wav

Resonance, i want to plot a system current transfer matrix element vs frequ...

i want to plot a system current transfer matrix element vs frequency curve.how can i draw it?any suggestion.

MATLAB support for fault analysis in transmission lines, The devices in pow...

The devices in power system shown in Figure 2 have the following ratings: G1 : 100 MVA, 13.8 kV grounded Y, X” = 0.15 pu, X2 = 0.015 pu Xo = 0.05 pu G2 : 50 MVA, 20.0 kV grounded

Common-emitter configuration, Common-emitter configuration: The commo...

Common-emitter configuration: The common-emitter that is abbreviated as CE transistor configuration is displayed in figure.  The transistor terminal common to both the input

Compute number of electrons and find their average velocity, Q. A wire with...

Q. A wire with n = 10 30 electrons/m 3 has an area of cross section A = 1mm 2 and carries a current i = 50 mA. Compute the number of electrons that pass a given point in 1 s, an

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd