Exit command, Computer Engineering

Assignment Help:

Your shell must accept the exit command. This command will be in the form:

e x i t

When you encounter this command, your shell should terminate. Please note that when your shell exits, you must restore the input parameters changed. This will be discussed later in this document.


Related Discussions:- Exit command

How e-commerce website works, Procedure The only difference between e-...

Procedure The only difference between e-commerce and conventional commerce is that goods in e-commerce are purchased over the internet using a credit card. Also buying and sel

Compute minimum value of the horizontal force, Compute minimum value of the...

Compute minimum value of the horizontal force: Block A of weight 520N rest on horizontal top of block B having weight of 700N as shown in the figure given below. Block A

Operating system., what is the minimum number of page faults for an optimal...

what is the minimum number of page faults for an optimal page replacement strategy?

What is the network service access policy, What is the Network Service Acce...

What is the Network Service Access Policy A high-level, issue-specific policy which defines those services that are allowed or denied from the restricted network. It also co

Write an algorithm for the braking system, Question: a) Consider a car ...

Question: a) Consider a car having a collision detection mechanism. Write an algorithm (in simple English) to illustrate the collision detection mechanism. b) The same car

How is EISA bus different from ISA bus, How is EISA bus different from ISA ...

How is EISA bus different from ISA bus? Extended Industry Standard Architecture (EISA) is a 32 bit modification to ISA bus. As computers became larger and had wider data buses,

Objectives-classification of parallel computers , Objectives After goi...

Objectives After going through this unit, you should be able to: Describe the diffrent criteria on which classification of parallel computers are based; Examine the

Write the command to show the ip host table, show hosts is the command whi...

show hosts is the command which display the IP host table

Two ways of converting a two input nand gate to an inverter, 1)      Short ...

1)      Short both I/Ps of NAND gate & use the gate as an inverter. 2)      Connect any one of the two I/Ps to VCC & use the remaining I/P & use the gate as an inverter.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd