Evaluate the shear plane angle, Mechanical Engineering

Assignment Help:

In an orthogonal cutting process, following data were taken. Chip length of 80mm was obtained with an uncut chip length of 200mm and the rake angle used was20 degrees and depth of cut 0.5mm. The vertical and horizontal components of cutting force FH and FV were 2000N and 200N respectively. Evaluate the shear plane angle, chip thickness, friction angle resultant cutting force.


Related Discussions:- Evaluate the shear plane angle

Thermal Stresses in Tapered Section, A rigidly fixed circular bar 1.75mm lo...

A rigidly fixed circular bar 1.75mm long uniformly tapers from 125mm dia. at 1 end to 100mm dia. at other end. If the max. stress in the bar is not to exceed 108MPa. Find the tempe

Calculate the overall fraction defective from all of sample, Calculate the ...

Calculate the overall fraction defective from all of sample: ABC insurance company desires to design a control chart to check whether insurance claim forms are being correctly

Necessity of brakes , Necessity of Brakes To stop a vehicle in nor...

Necessity of Brakes To stop a vehicle in normal as well as emergency conditions. To slow down the speed to turn, pass hurdles etc.

Enthalpy - thermodynamics, Enthalpy: Sol: The enthalpy is total ener...

Enthalpy: Sol: The enthalpy is total energy of gaseous system. It takes into consideration, internal energy and pressure, volume effect. Thus, it can be defined as follows:

Design of the plc ladder and profibus - asi network, 1 Prepare an updated s...

1 Prepare an updated sketch of the electro-hydraulic system shown in Figure showing the actuators in their start position appropriate to your allocated actuator sequence. 2 By u

Branches of mechanics, Branches of mechanics: Mechanics is basically d...

Branches of mechanics: Mechanics is basically divided in to two parts Static's and Dynamics, Dynamics is further divided in kinematics and kinetics Statics: It deals with

Wilson-Hartnell Governor:, A Wilson-Hartnell governor is illustrated in giv...

A Wilson-Hartnell governor is illustrated in given Figure. In this, the balls are associated by two springs that are known as main springs. The main springs are symmetrically arran

Design close coiled helical compression spring, Prepare a design of close c...

Prepare a design of close coiled helical compression spring for a service load ranging from 2250 N to 2750 N. The axial deflection of the spring for the load range is 6 mm. Conside

Damping, physical meaning of viscous damping

physical meaning of viscous damping

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd