equilibrium of rigid bodies, Mechanical Engineering

Assignment Help:
Ask question #MinimumThe man is pulling a load of 4kg with one arm held as shown. Determine the force FH this
exerts on the humerus bone H, and the tension developed in the biceps muscle B.
Neglect the weight of the man’s arm. Refer fig.2. 100 words accepted#

Related Discussions:- equilibrium of rigid bodies

What are the forces acting on foundations, What are the Forces Acting on Fo...

What are the Forces Acting on Foundations Foundations are normally subjected to vertical loads which are resisted by compressive stress generated in the soil. However, the acti

Design control room for plant, Q. Design Control Room for plant? Some e...

Q. Design Control Room for plant? Some equipment may need to be located inside buildings, but this needs to be justified as it incurs additional cost and can create additional

Determine the initial radius of curvature, Determine the initial radius of ...

Determine the initial radius of curvature:  A carriage spring, defiantly loaded and simply supported at its ends, has 12 steel plates each 60 mm wide by 6 mm thick. If the lon

Fixed support, Fixed Support: At such support beam end is not free to tran...

Fixed Support: At such support beam end is not free to translate or rotate at the fixed end there are three reaction horizontal reaction ( R H ), a vertical reaction ( R V ), an

Describe cold extrusion, Q. Describe Cold extrusion? • Cold extrusio...

Q. Describe Cold extrusion? • Cold extrusion is done at room temperature or near room temperature. • The advantages of this over hot extrusion are the lack of

Find span of the beam, A beam is simply supported and carries a uniformly d...

A beam is simply supported and carries a uniformly distributed load of 40kn/m run over whole length or span. The section of the beam is rectangular having depth as 500mm. If the s

Airport drainage, Airport Drainage: Rainwater should be quickly taken...

Airport Drainage: Rainwater should be quickly taken away from the runway, taxiway and apron areas. For drainage of runway and taxiway, a cross-slope of 1.5 per cent on either

Evaluate total extraction, Evaluate total extraction: The steel tie r...

Evaluate total extraction: The steel tie rod 50mm in diameter and 2.5m long is subjected to pull of 100 KN . To what length the rod must be bored centrally so that total ext

Thermodynamics, Convert the following readings of pressure to KPa absolute,...

Convert the following readings of pressure to KPa absolute, assuming that the barometer reads 760mm Hg: (a) 100 psig, (b) 8in. Hg vacuum, and (c) 76in Hg gage.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd