Editing dimensions-autocad, Mechanical Engineering

Assignment Help:

Editing Dimensions

The dimension edit commands, DIMEDIT and DIMTEDIT are used basically to adjust the position of the text part of a dimension. This is usually only necessary, if the drawing is quite complex and the dimension would read it more clearlyif its in different position.

 


Related Discussions:- Editing dimensions-autocad

Calculate energy and entropy - thermodynamics, Thermodynamics. Justify that...

Thermodynamics. Justify that it is the science to calculate energy, energy and entropy. Sol : Thermodynamics is science which deals with conversion of heat into mechanical e

What is the procedure of hot working, Q. What is the procedure of hot worki...

Q. What is the procedure of hot working? A process is defined as hot working if it takes place when the workpiece is above the recrystallization temperature. Hot Working Ad

Section modulus and value of bending moment, Q. Wha t do you mean by secti...

Q. Wha t do you mean by section modulus ( Z )? What is value of bending moment in the terms of section modulus? Sol.: Section modulus is ratio of M.I. about neutral ax

English, what is law of gearing

what is law of gearing

Difference between the open and closed systems, Provide short answers to th...

Provide short answers to the following questions: a)   What the necessary condition for a heat transfer process to occur? b)   What is a difference between the steady state c

Show dike heights and distance from containers, Wall-type bunds / dikes for...

Wall-type bunds / dikes for storage compounds should be from 0.5 m to 1.5 m high (1.5 ft. - 5 ft. - check local codes and regulations), depending on the required containment capaci

Machin of dynamics, Ask question Prove maximum fluctuation of energy ?E=2EC...

Ask question Prove maximum fluctuation of energy ?E=2ECS.

Determine magnitude of the couple, Determine magnitude of the couple: ...

Determine magnitude of the couple: A square block having each side 1.5 m is acted upon by system of forces along its sides as shown in the adjoining figure. If system reduces

Brazing vs welding, Brazing Vs Welding Following are the differences be...

Brazing Vs Welding Following are the differences between brazing and welding. (i)  In brazing, the joint surfaces are not raised to fusion point (or melted) and the joint is

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd