Draw the bending moment and shear force diagrams, Mechanical Engineering

Assignment Help:

A cantilever beam of 4 metre length is loaded with uniformly distributed load of 20 KN/m throughout the whole beam. It is also loaded with 30 KN operating at 3m from the fixed end and 20 KN load operating at 2m from fixed end. Draw the Bending moment and shear force diagrams.

Related Discussions:- Draw the bending moment and shear force diagrams

Mechanics of solids, 3-d stress&strains

3-d stress&strains

Corrosion resistance of tantalum, Q. Corrosion resistance of tantalum? ...

Q. Corrosion resistance of tantalum? Tantalum is readily attacked by strong alkalis, even at room temperature, and therefore, is not suitable for use in processes where the pH

Calculate the temperature at the center of the pipe, Heat generated uniform...

Heat generated uniformly in Stainless steel plate having k=20 W/m. 0 C. The thickness of the plate is 1cm and the heat generation rate is 500 MW/m 3 . If the two sides of the plate

Calculate number of cycles to fracture, Calculate number of cycles to fract...

Calculate number of cycles to fracture: If the plastic deformation is taken into consideration calculate number of cycles to fracture in above Example. Solution Δ K I

Try square-measuring tools , Try Square: It has two straight edge arms at ...

Try Square: It has two straight edge arms at the angle of 90 degree and it is used to check the perpendicularity. A try square is shown in Figure. Figure: Try Square

Find out the intensity of the external pressure, Find out the intensity of ...

Find out the intensity of the external pressure: A thick cylinder of 0.5 m external diameter & 0.4 m internal diameter is subjected simultaneously to internal & external press

Friction is undesirable, Friction is Undesirable: A friction is undesi...

Friction is Undesirable: A friction is undesirable at the time of ice skating or when the block is lifted or put down on the truck with the help of inclined plane. If friction

Explain concept of reaming of radial drilling machine, Explain concept of R...

Explain concept of Reaming and boring of radial drilling machine Reaming Reaming is accurate way of sizing and finishing the pre-existing hole. Multi tooth cutting tool. A

Material and tribology, The Cu-Sb system contains 2 eutectics, 1 eutectoid,...

The Cu-Sb system contains 2 eutectics, 1 eutectoid, 1 peritectic and 1 peritectoid. Mark them all on the figure, write down the temperature and composition of each point, and ident

Feathering system, what is feathering system in turbo prop type aircraft

what is feathering system in turbo prop type aircraft

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages