Differences between torque and torsion, Mechanical Engineering

Assignment Help:

Differences between torque and torsion:

Give differences between torque and torsion. List a few examples of torsion in the engineering practice.
Sol.: When structural or machine member is subjected to moment about the longitudinal axis of it, the member twists and shear stress is induced in the every cross section of member.

This type of mode of loading is called as TORSION. And twisting moment is referred to as TORQUE.

Example: Screw driver, Door knob, drill bit and shaft.

Related Discussions:- Differences between torque and torsion

Find distance of which wagon will travel before coming rest, Find distance ...

Find distance of which wagon will travel before coming rest: A train of wagons is first pulled on level track from A to B and then up a 5 percent upgrade as shown in the figur

Work, proof of work being a path function

proof of work being a path function

Determine in detail about the depth of foundation, Location with Respect to...

Location with Respect to Depth The depth below ground level at which the bottom of a foundation structure is located depends on number of factors, the most important of which

About cam''s use, Which type of cam is used in general 2 wheelers?and how t...

Which type of cam is used in general 2 wheelers?and how the type of profile is determined?

Magnetic susceptibility and ferromagnetic substances, Magnetic Susceptibili...

Magnetic Susceptibility and Ferromagnetic Substances: Magnetic Susceptibility: The magnetic susceptibility (c) of a substance is defined as the ratio of the intensity of magn

Determine the largest value of force, Do not round intermediate calculation...

Do not round intermediate calculations; however for display purposes report intermediate steps rounded to four significant figures. Give your final answer(s) to three significant f

What do you understand by interference, (a) Derive a mathematical expressio...

(a) Derive a mathematical expression for Maximum length of path of Contact, Maximum Length of Arc of Contact and Contact Ratio in case of Interference. (b) What do you understan

Classification based on mode of welding, Classification Based on Mode of We...

Classification Based on Mode of Welding Manual welding: In this welding the entire welding operation is performed and controlled by hand. Here, there are two movements involv

Explain general phase of radial drilling machine, General Phase of Radial D...

General Phase of Radial Drilling Machine Steps- 1. Prepare a strong foundation for the value study. In radial drilling machine hole can not be produce in any angle.

Multistage reciprocating air compressor, p-v diagram

p-v diagram

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages