Difference between the communication and transmission, Computer Networking

Assignment Help:

Communication is the process of sending and receiving data by means of a data cable that is associated externally.

Transmission means the transmitting of data from the source to the destination.

Related Discussions:- Difference between the communication and transmission

Flash-nvram-system buffer-interface buffer, Flash It is also permanent...

Flash It is also permanent storage device. It stores the compressed form of Cisco IOS software image and the NVRAM data. Device structure One flash socket Support 80

Packet, a transperent switch is inserted between two local area networks AB...

a transperent switch is inserted between two local area networks ABC and XYZ.network ABC has workstation 1,2,and 3 and Network XYZ has workstation 4,5, and 6. show the contents of

Single-cell wireless lan, Single-cell wireless LAN All of the wireless ...

Single-cell wireless LAN All of the wireless end systems are within range of a single control module. Multiple-cell wireless LAN: there are many control modules interlinked by

Verify vlans and trunking - ccna, Verify VLANs and trunking. Use the sh...

Verify VLANs and trunking. Use the show ip interface trunk command on S1 and the show vlan command on S2 to determine that the switches are trunking correctly and the proper VL

Which layer is responsible for negotiating data transfer , Which layer is r...

Which layer is responsible for negotiating data transfer syntax? Ans) The Presentation layer does the following: Manages data representation conversions, or data transfer syntax

Disadvantages of ip sec tunnelling mode, Disadvantages of IP sec Tunnelli...

Disadvantages of IP sec Tunnelling mode IP sec tunnelling mode has the following disadvantage a.Encryption of small packets generates a lot networks over head thu

Introduction to operating system for parallel computer, INTRODUCTION T...

INTRODUCTION This part discusses the additional requirements at software levels and operating system which will create the parallel programs run on parallel hardware. Collecti

Router components - network layer and routing , Router Components As no...

Router Components As noted in the previous a router consists of a of input interfaces at which packets arrive and a set of output interfaces from which packets depart. T

Network comp. architecture, Write discussion on Associative mapping - compu...

Write discussion on Associative mapping - computer architecture

Explain the structure of a typical ethernet frame, Question: (a) The IE...

Question: (a) The IEEE 802 series of standards describe both the Physical and Data Link layers of their respective technologies. Two important standards are 802.3 and 802.5, r

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages