Difference between mill and mill-drill, Mechanical Engineering

Assignment Help:

What is difference between mill and mill-drill?

Ans) Today many manufactures are combining machines; a mill/drill is one of these. It is a mixture of a drill and a mill, a mill removes stock from material (usually metal, but not limited just to metal, it depends on your application), you use fluted cutters like end mills. The drill aspect of the machine is just that it drills holes, with the proper speed for the right size drill.

Related Discussions:- Difference between mill and mill-drill

Biofluids mechanics, in fontan circulation that is represented as a circuit...

in fontan circulation that is represented as a circuit

.computer science and data structure, write an algorithm to calculate simpl...

write an algorithm to calculate simple intrest

Determine the service and backwash rates, Service duty point: 3 m3/h Backw...

Service duty point: 3 m3/h Backwash duty point: 9 m3/h Part (a) What is the speed of the pump to achieve the service and backwash flow rates ? Part (b) What would be the best

Formulate the equation of motion, Figure shows a reinforced concrete framed...

Figure shows a reinforced concrete framed building subjected to earthquake ground motion. The floor is rigid with the mass of each floor is shown in the figure. Formulate the equat

Find the out value of force - cantilever truss, A cantilever truss is loade...

A cantilever truss is loaded and supported as shown in the figure given below. Find the out value of P , which would produce an axial force of magnitude 3KN in member AC .

Equipment for resistance welding-stored energy equipments, EQUIPMENT FOR RE...

EQUIPMENT FOR RESISTANCE WELDING-Stored energy equipments Energy can be stored and further utilised for welding. One method of storing energy is in capacitors electrostat

Strengh of material, case study of thermal stresses and composite bar

case study of thermal stresses and composite bar

Babbitts- bearing materials, Bearing Materials Generally it can be sai...

Bearing Materials Generally it can be said as a good bearing material must posse following characteristics as: It must be strong enough to sustain bearing load. It

Differences between direct stress and bending stress, Give differences betw...

Give differences between direct stress and bending stress. Direct tensile and compressive stress is set up because of load applied parallel to length of object, and direct shea

Compressive strain, Compressiv e Strain: When the compressive load ac...

Compressiv e Strain: When the compressive load acts on body then there will be an increase in cross sectional area and decrease in length of body. The ratio of reduction in l

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages