Determine the Service and Backwash Rates, Electrical Engineering

Assignment Help:
Determine the Service and Backwash Rates

The system on site is a pressure sand filter, with a service curve. The filter is backwashed using the feed pump, at a higher flow rate, shown as backwash curve.



Service duty point: 3 m3/h

Backwash duty point: 9 m3/h

Part (a)

What is the speed of the pump to achieve the service and backwash flow rates ?

Part (b)

What would be the best way to control the speed of the pump ? Why ?

Part (C)

The pump is set up as a fixed speed constant pressure system (pump runs once system pressure reaches 550 kPa, turns off, when pressure drops to 450 kPa plant re-starts) to maintain a system pressure of 500 kPa at the discharge of the pump. What would be the service and backwash rates from the pump ?

Related Discussions:- Determine the Service and Backwash Rates

Find the per-phase impedance of the load, Q. A three-phase, three-wire 208-...

Q. A three-phase, three-wire 208-V system is connected to a balanced three-phase load. The line currents ¯ IA, ¯ IB, and ¯ IC are given to be in phase with the line-to-line voltage

Explain about address structure, Q. Explain about Address Structure? A...

Q. Explain about Address Structure? Address Structure: ISDN address structure is illustrated in figure. ISDN number part has a maximum of 15 digits and ISDN sub address part

Discuss direct memory access, Discuss DMA definition. Direct memory ac...

Discuss DMA definition. Direct memory access (DMA) is a process wherein an external device takes over the control of system bus by the CPU. Direct memory access is for high-sp

How a nand gate decoder is used for 2716 eprom memory, With neat diagram in...

With neat diagram indicate how a simple NAND gate decoder is used to select a 2716 EPROM memory component for memory locations FF800H-FFFFFH. Simple NAND gate Decoder: As the 2

Explain synchronisation and parallel operation, Explain Synchronisation and...

Explain Synchronisation and Parallel Operation Generation, transmission and distribution of electric power have to be conducted in an efficient and reliable way at a reasonable

Integrated circuit components, You are required to design and document the ...

You are required to design and document the hardware design for Lift Control Unit (LCU) as required by the questions/specification in section 2 above, based on a 68HC12D60 microcon

What is key bouncing, What is Key bouncing? Mechanical switches are us...

What is Key bouncing? Mechanical switches are used as keys in lots of the keyboards. When a key is pressed the contact bounce back and forth and settle down only after a littl

Find the percent voltage regulation of the transformer, Q. A 25-kVA, 2400/2...

Q. A 25-kVA, 2400/240-V, 60-Hz, single-phase transformer has an equivalent series impedance of 3.45 + j5.75  referred to the primary high voltage side. The core loss is 120 W. Whe

Concept of flux density, We can illustrate the direction and strength of a ...

We can illustrate the direction and strength of a magnetic field by means of drawing 'flux lines'. These have arrows to show the direction of the magnetic field at any point and th

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd