Determine the power rating of compressor motor, Electrical Engineering

Assignment Help:

An ice plant produces 12tonn of ice per day at 00C using water at 300C. The plant operates on reversed Carnot cycle between -150C and 280C. If the actual C.O.P. is 50% of the ideal C.O.P. and the overall electromechanical efficiency is 0.8, Determine the power rating of compressor motor. Latent heat of ice is 335KJ/kg, specific heat of water is 4.18KJ/kgK. With the help of neat graph and T-S diagram illustrate the working of simple air cooling system used in air craft.


Related Discussions:- Determine the power rating of compressor motor

Field effect transistor, Field effect transistor: Primarily difference...

Field effect transistor: Primarily difference between bit and jet is that bit transistor is a current controlled device while jet is a voltage controlled device.  Is a direct

Determine the induced voltage at full load, A 100-kW, 250-V shunt generator...

A 100-kW, 250-V shunt generator has an armature-circuit resistance of 0.05  and a field- circuit resistance of 60 . With the generator operating at rated voltage, determine the i

Show demagnetizing effect of armature reaction, Q. A20-hp, 250-Vshuntmotor ...

Q. A20-hp, 250-Vshuntmotor has a total armature - circuit resistance of 0.25  and a field-circuit resistance of 200.At no load and rated voltage, the speed is 1200 r/min, and the

Basic definition of electromagnetism, Q. Basic definition of electromagneti...

Q. Basic definition of electromagnetism? A basic understanding of electromagnetism is essential to the study of electrical engineering because it is the key to the operation of

Registers - microprocessors architecture , Registers Various  register...

Registers Various  registers  shown in figure  are discussed  below  in detail.

FLOW CHART TO RUN MOTOR, IFYOU AVE TWO DC MOTOR,RELAY,TWO BATTERYAND MICROC...

IFYOU AVE TWO DC MOTOR,RELAY,TWO BATTERYAND MICROCONTROLLER FLOW CHART TO RUN MOTOR AND CONTROL TWO BATTERIES

Objective of long-term plans for technical loss reduction, Objective of Lon...

Objective of Long-Term Plans for Technical Loss Reduction The primary objectives of strengthening and improvement of sub-transmission and distribution system in the long-term

What is the need of the resistance used in a clipper, Q. What is the need o...

Q. What is the need of the resistance used in a clipper? Resistor is used in a clipper to limit the current through the diode. To avoid the damage due to excessive current thro

Draw the block diagram of phase cancellation ssb generator, a. The antenna ...

a. The antenna current of an AM broadcast transmitter, modulated to depth of 40% by an audio sine wave is 11 amp. It enhances to 12 amp as a result of simultaneous modulation by an

Logic Gates, XOR gate BY using NAND gate Only

XOR gate BY using NAND gate Only

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd