Determine the loss in post-tensioned members, Civil Engineering

Assignment Help:

Determine the Loss in post-tensioned members

This loss occurs only in post-tensioned members. There always exists a certain amount of friction in the jacking and anchoring system and on the walls of the duct.. So, the actual stress in the tendon is less than what is indicated by the pressure gauge.


Related Discussions:- Determine the loss in post-tensioned members

Explain about warren truss, Q. Explain about Warren Truss? A truss is a...

Q. Explain about Warren Truss? A truss is a simple structure whose members are subject to axial compression and tension only and however not bending moment. The most common tru

Deflectin of beam, simply supported beam with point load at the centre

simply supported beam with point load at the centre

Haley''s formula in pile driving, Question What is major difference bet...

Question What is major difference between "hammer efficiency" and "coefficient of restitution" at what time using Haley's formula in pile driving?   Answer Hammer ef

Geotechnical engg., friction circle method of stability of slope

friction circle method of stability of slope

Determine the settlement of the foundation, The thiclcness of the normally...

The thiclcness of the normally consolidated soft clay layer is 6 m. The natural water content is 31 percent. The specific gravity of the soil being 2.68 with a liquid limit of 4

Concrete, What is Polymer Concrete?

What is Polymer Concrete?

BESHOOOOO, what are the dimensions of a sheet of paper required for plottin...

what are the dimensions of a sheet of paper required for plotting a traverse ABCDE with 1 : 250 scale if a margin of 4 cm to the right and left sides and a6 cm margin to the other

Basic considerations governing selection of road alignment, Basic Considera...

Basic Considerations Governing Selection of Road Alignment: The following considerations shall be kept in view in selecting the road alignment: Roads in Plain Areas (a)

Principles and Practices of Management, How Will You Influence People to St...

How Will You Influence People to Strive Willingly for Group Objectives in Your Organization (Target Based Industry)? Apply Your Interpersonal Influence Through Communication Proces

Mechanics of solids, what is difference between design moment, nominal, req...

what is difference between design moment, nominal, required, resisting and ultimate moment ?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd