Determine the current needed in the coil to produce a flux, Electrical Engineering

Assignment Help:

Q. Consider the magnetic circuit shown in Figure. Assume the relative permeability of the magnetic material to be 1000 and the cross-sectional area to be the same throughout. Determine the current needed in the coil to produce a flux density of 1 T in the center limb, if the excitation coil has 500 turns.

290_Determine the current needed in the coil to produce a flux.png


Related Discussions:- Determine the current needed in the coil to produce a flux

#speed control, explain speed control of dc motor

explain speed control of dc motor

What is dtmf dialling, Q. What is DTMF dialling? DTMF dialling 1. ...

Q. What is DTMF dialling? DTMF dialling 1.  Uses push buttons 2.  Uses 8 different frequencies in pairs. 3.  16 different characters can be represented. 4.  The f

Change in an organisation, Change in an organisation: Change might ...

Change in an organisation: Change might be perceived in two ways: Change as continuous and intrinsic to an organisation and change as discontinuous & extrinsic. A force

Microcontroller interfacing, The winch uses a 415 Volt 50 Hz AC motor, so b...

The winch uses a 415 Volt 50 Hz AC motor, so both the up/down and run/stop controls actually operate +24V relays, whose contacts switch the 415Vac to the winch. The relays also pro

Square wave generator ( 10 MHz to 20MHz), I need a simple design of above ...

I need a simple design of above mentioned , this oscillator will be used in a wireless power transmission

Dual trace and dual beam cro, what is difference between dual trace and dua...

what is difference between dual trace and dual beam cro?

What would the cutoff frequency, Q. The cutoff frequency of a dominant mode...

Q. The cutoff frequency of a dominant mode in an air-?lled rectangular waveguide is 3 GHz. What would the cutoff frequency be if the same wave - guide were ?lled with a lossless di

Determine the full load voltage regulation, A 25KVA, 3 phase, wye-connected...

A 25KVA, 3 phase, wye-connected, 400v synchronous generator has a synchronous impedance of 0.05 +j1.6 ohms per phase. Determine the full load voltage regulation at (a) 0.8 power

Why is an emitter bypass capacitor in amplifier, Q.  Why is an emitter bypa...

Q.  Why is an emitter bypass capacitor used in an RC coupled amplifier? If an emitter resistor Re is used for self-bias in an amplifier and if it is desired to avoid the degene

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd