Designing water storage tank, Civil Engineering

Assignment Help:

Question

While designing water storage tank, has movement joints be installed?


Answer

While designing water storage tanks, group joints can be set up in similar with steel reinforcement. To manage movement of concrete due to migratory variation of temperature, hydration temperature drop and reduction. Two primary methods in design are used- to plan closely spaced steel reinforcement to cut down spacing of cracks, thereby dropping crack width of cracks; to initiate movement joints to let a portion of movement to occur in joints.

 


Related Discussions:- Designing water storage tank

State the effect of the induction of the pre-stresses, State the effect of...

State the effect of the induction of  the pre-stresses The net effect of the induction of  the pre-stresses shall be to decrease the tensile stresses (produced due to the exte

Levelling, important terms used in levelling

important terms used in levelling

State average increase of pressure in the clay stratum, A building was to b...

A building was to be constructed on a clay stratum. Preliminary analysis showed a settlement of 60 mm in 6 years and an ultimate settlement of 250 mm. The average enhance of pressu

Design nominal reinforcement for staircase, Question Given a 1meter hig...

Question Given a 1meter high staircase resting on solid concrete, could it be adequate to design nominal reinforcement for staircase? Answer For design of staircase,

Laplace transform, Using Laplace transfom, the following differential equat...

Using Laplace transfom, the following differential equation d y dy dt reduces to the algebraic equation of the form Resolve y(s) into partial fractions

Determine about the statement - failure at cracking load, Determine about t...

Determine about the statement - Failure at Cracking Load This brittle mode of failure is likely to occur in those pre-stressed elements that are concentrically pre-stressed wit

Water absorption test - tests on stones, Water Absorption Test: In t...

Water Absorption Test: In this test cube specimen weighing approximate 50 grams are prepared and the test is carried out in the steps following: 1.    Note down the weigh

door shutters, what is the difference between paneled and glazed shutte

what is the difference between paneled and glazed shutter

Calculation of crack widths arising from thermal movement, Q. Calculation o...

Q. Calculation of crack widths arising from thermal movement In the calculation of thermal movement, the below formula is used in most codes: w max =s x a x (T 1 +T 2 )/2

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd