Design temporary storage, Mechanical Engineering

Assignment Help:

Q. Design Temporary Storage?

It is sometimes acceptable to store drums temporarily on spill containment pallets. Each pallet should be capable of capturing the contents of at least one of the drums if there is a leak. If these pallets are to be used, the drums must be stored in a level area (to ensure full spill storage capacity), and they must be covered so that the pallets do not fill with rainwater.

Temporary bunding / diking arrangements should ensure that there is only localized contamination in the event of a spill.


Related Discussions:- Design temporary storage

Flange facing and surface finish, Q. Flange Facing and Surface Finish? ...

Q. Flange Facing and Surface Finish? Raised face flange facings are preferred. Flat face flanges to be used only when mating with like equipment (fabricated from brittle mat

Thermodynamics, microscopic and macroscopic view points

microscopic and macroscopic view points

Gage factor and transverse sensitivity of the gage, A biaxial rosette is sh...

A biaxial rosette is shown at right. Derive equations to correct for transverse sensitivity effects for the case in which the two strain gage elements exhibit different gage factor

Introduction to advance manufacturing, INTRODUCTION In the morning se...

INTRODUCTION In the morning session there was a discussion about what the teachers are going to do in this week. Later the professor has shown power point presentation on int

Describe cold extrusion, Q. Describe Cold extrusion? • Cold extrusio...

Q. Describe Cold extrusion? • Cold extrusion is done at room temperature or near room temperature. • The advantages of this over hot extrusion are the lack of

Tolerances, difference between geometric and amnufacturing tolerances

difference between geometric and amnufacturing tolerances

Draw the bending moment diagram and shear force diagram, Draw the bending m...

Draw the bending moment diagram and shear force diagram: A cantilever beam of 8 m length is subjected to point loads of 15 kN, 10 kN, 25 kN and 20 kN at distances of 4 m, 2 m,

Find the minimum weight to keep equilibrium, Find the minimum weight to kee...

Find the minimum weight to keep equilibrium: A belt supports the two weights W 1 an d W 2 over a pulley as shown in the figure given below. If W 1 = 1000N, fi

Explain interpoles or commutating poles, Interpoles or commutating poles ...

Interpoles or commutating poles Interpoles are ?xed to the frame in among main poles. They are used for sparkless commutation, i.e, to improve commutation.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd