Design close coiled helical compression spring, Mechanical Engineering

Assignment Help:

Prepare a design of close coiled helical compression spring for a service load ranging from 2250 N to 2750 N. The axial deflection of the spring for the load range is 6 mm. Consider a spring index of 5. The permissible shear stress intensity is 420 MPa and modulus of rigidity G = 84 kN/mm². Neglect the effect of stress concentration.

Related Discussions:- Design close coiled helical compression spring

Newton''s second and third law of motion, Newton's second and third law o...

Newton's second and third law of motion: Newton's second law of motion: If resultant force is acting on particle is not zero, and then acceleration of particle will be prop

Renewable Energy, I am attending Thermodynamics class at the university. Th...

I am attending Thermodynamics class at the university. The professor asked me to write a research on Renewable Energy: Solar Power. The report should be of 10 pages and at least 10

Introduction to fuel cell technology workshop , Introduction There was...

Introduction There was a power point presentation on Hydrogen fuel, Hydrogen production using electrolyzer and solar energy and solar energy.Topics like Alternative Energy Sys

Nitrogen storage and vaporizer, Q. Nitrogen storage and vaporizer? Bulk...

Q. Nitrogen storage and vaporizer? Bulk cryogenic storage of nitrogen must be located away from process equipment, preferably at the edge or corner of the process area where fi

Throttle free play adjustment of motor cycle, Throttle Free Play Adjustmen:...

Throttle Free Play Adjustmen: A smooth operation of the throttle ensures proper acceleration of the vehicle according to the requirement of the rider. If the throttle cable is kin

Explain co-planar parallel force, Illustrate following key terms with suita...

Illustrate following key terms with suitable example :- (a) Co-planar parallel force. (b) Co-planar non concurrent force. (c) Non co-planar concurrent force.

Torsion of cylinder and torsion rigidity, I want complete information about...

I want complete information about the topic torsion of cylinder and torsion rigidity.if I have to make a project on this topic then how should I make it. Please help me sir.

Gathering lines, Gathering Lines: A gathering line, also called a lad...

Gathering Lines: A gathering line, also called a ladder track, is one into which a number of parallel tracks merge. This is shown in Figure. It is used in marshalling yards.

Determine the buckling load, (a) Evaluate the buckling load of column with ...

(a) Evaluate the buckling load of column with one end fixed other free of 8m length by using Euler's formula. Given : I min = 1390m 4 E = 2 X 10 5 N/mm 2 (b) Derive a

Steps of engine oil replacement and top-up, Engine Oil Replacement and top ...

Engine Oil Replacement and top up steps • The engine oil should be changed only when motorcycle has run through the prescribed kilometers. • Change the engine oil every 4000 k

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages