Describe what is rim and sim instructions, Electrical Engineering

Assignment Help:

RIM is Read Interrupt Mask. Used to ensure whether the interrupt is Masked or not.    

SIM is Set Interrupt Mask. Used to mask the hardware interrupts. 

 

 


Related Discussions:- Describe what is rim and sim instructions

Explain time-dependent circuit analysis, Q. Explain Time-Dependent Circuit ...

Q. Explain Time-Dependent Circuit Analysis? The response of networks to time-varying sources is considered in this chapter. The special case of sinusoidal signals is of particu

Advantages of high level languages , Advantages of High  level  Languages...

Advantages of High  level  Languages a.It is  easy  to learn  write and debug  the program  written in high  level  languages. b.Programs are more  legible as compared to m

Explain current divider rule, Explain current divider rule Current flow...

Explain current divider rule Current flow through at every resistor that connected by parallel can be find by using current divider rules (CDR).

What is meant by regulation, Q. What is meant by regulation? The output...

Q. What is meant by regulation? The output of most power supplies should be a constant voltage. Unfortunately, this is difficult to achieve. There are two factors that can caus

Resistance temperature sensor, A Platinum resistance temperature sensor has...

A Platinum resistance temperature sensor has a resistance of 120 ohm at 0°C and forms one arm of a Wheatstone bridge. At this temperature the bridge is balanced with each of the ot

Economic analysis of hydropower, find the net value of power if an average ...

find the net value of power if an average value of energy is assumed to be $0.05/KWh, the capacity value is $30/kw-yr ...

What is maximum memory size that can be addressed by 8086, What is the maxi...

What is the maximum memory size that can be addressed by 8086? In 8086, an memory location is addressed by 20 bit address and the address bus is 20 bit address and the address

TTL input logic circuit, I am building a testing device for the purpose of ...

I am building a testing device for the purpose of screening a 5801 BiMOS 8 BIT Parallel-input Latched Driver, I need help with input circuit to drive all 8 outputs one at a time. M

Discuss all the five software interrupt instructions, Discuss all the five ...

Discuss all the five software interrupt instructions. The INTEL family microprocessor consist of software interrupts INT, INT0, INT3 and BOUND and IRET. Out of all these five

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd