Define what is the mac address, Computer Networking

Assignment Help:

When you move the NIC cards from one PC to another PC, does the MAC address gets transferred as well?

Yes, that's because MAC addresses are hard-wired into the NIC circuitry, not the PC. This also means that a PC can have a dissimilar MAC address when the NIC card was change by another one.

 


Related Discussions:- Define what is the mac address

What is subnet mask, What is subnet mask? A subnet mask is combined wit...

What is subnet mask? A subnet mask is combined with an IP address in order to recognize two parts: the extended network address and the host address. Such as an IP address, a s

Will the client send a tcp or udp packet, Question: (a) Explain the usa...

Question: (a) Explain the usage of the following parts of the IPv4 datagram format. i. VERS ii. HLEN iii. TOTAL LENGTH iv. SERVICE TYPE v. HEADER CHECKSUM (b) Na

eigrp protocol update route information, How does EIGRP protocol update ro...

How does EIGRP protocol update route information to its neighbors

What is difference among flsm and vlsm, In FLSM subnet mask of all subnets ...

In FLSM subnet mask of all subnets will b same. But in FLSM it changes.

Name the categories of multiplexing, Name the categories of Multiplexing? ...

Name the categories of Multiplexing? There are three categories of multiplexing a. Frequency Division Multiplexing (FDM) b. Time Division Multiplexing (TDM)    i. Sync

Low frequency cut-off of the band-pass, Question Approximately what is ...

Question Approximately what is the low frequency cut-off of the band-pass filter shown in the figure?

What are routers, What are routers? Routers work to connect two or more...

What are routers? Routers work to connect two or more network segments. These are the most intelligent network devices that store information in its routing table like paths, h

What does ''p'' mean when running a trace, When a P is returned when a Trac...

When a P is returned when a Trace is run, it means the Protocol is unreachable.

What do you use the aux port for, The auxiliary port is used to link a mode...

The auxiliary port is used to link a modem to for dial backups.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd