Define the hazardous waste, Civil Engineering

Assignment Help:

Define the Hazardous Waste

1. Any waste or combination of waste that poses a substantial danger now or future to humans, plants, and animals without special precautions.

2. There are cases where waste has been declared safe or non-hazardous, but years later cause a lot of hazardous problems

3. Waste material is considered to be hazardous if it is on the EPA developed lists (F, K, P, U, etc.).


Related Discussions:- Define the hazardous waste

Calculate the daily standard production rate of equipment, Calculate the Da...

Calculate the Daily Standard Production Rate of Equipment An excavator with a bucket capacity of 3-yd 3 has a standard operating cycle time of 40 seconds. The daily standard p

Surveying, define surveying and where it is involved

define surveying and where it is involved

Conducting triaxial test, Question In conducting triaxial test to deter...

Question In conducting triaxial test to determine shear strengths for soil samples, what consolidation pressures should be specified? Answer It appears that the sele

Functions components of a typical expansion joint, Question What are the fu...

Question What are the functions components of a typical expansion joint ? Answer In a characteristic expansion joint, it normally contains following mechanism-joint sealant, jo

Ghgh, Ask quhestion #Minimum 100 words accepted#

Ask quhestion #Minimum 100 words accepted#

Calculate the actual water cement ratio, Calculate the Actual Water Cement ...

Calculate the Actual Water Cement Ratio A jobsite delivery ticket is shown below for a grout mix.  The actual w/c ratio is most nearly: Solution:       Note, althou

Material of steel tendons, Material of steel tendons The material of s...

Material of steel tendons The material of steel tendons also must be of a high strength. Tendons should possess required material and geometrical properties so that a desired

Upper floor, We need all types of Upper floor

We need all types of Upper floor

IRC Class AA loading in existing industrial areas, For IRC Class AA loading...

For IRC Class AA loading in existing industrial areas, what is load (kN/m) has to applied base don the wheel loads. especially raft foundation & roads are at same level.

Addition of water to bored piles, Addition of water to bored piles In ...

Addition of water to bored piles In water bearing ground, some water head (about 1 m) above the existing ground water table is sustained to stabilize the bore at the time of e

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd