Define multiple inputs - control system, Electrical Engineering

Assignment Help:

Define Multiple Inputs - Control System

When there is much more than one input to a system, the superposition principle can be employed. This is that:

The response to various inputs simultaneously applied is the sum of the individual responses to each input when applied separately. So, the procedure to be adopted for a multiple input-single output (MISO) system is:

a) Set all but one of the inputs to zero.

b) Determine the output signal due to this one non-zero input.

c) Repeat the above steps for each input in turn.

The total output of the system is the algebraic sum of the outputs because of each of the inputs.


Related Discussions:- Define multiple inputs - control system

Speed control of dc motor using pid, The objective of the project is to pro...

The objective of the project is to protect damage of the DC motors. If the motor is not working it will be shown with red light, if working normally then green and if working at a

Depletion type mosfet, Depletion type MOSFET The channel is of silico...

Depletion type MOSFET The channel is of silicon. It can be two type of channel that is an n-type or p-type channel; it is still mostly silicon. After that, we take note that

Network topology, LAN topologies: Network topology is a physical schematic...

LAN topologies: Network topology is a physical schematic that demonstrates interconnection of the many users. There are four fundamental topologies as under: (i) Direct Connect

What is the difference between a tem mode and a te mode, Q. (a) What is the...

Q. (a) What is the difference between a TEM mode and a TE mode? (b) Explain the terms "cutoff wavelength" and "dominant mode" as applied to waveguides. Find the cutoff wavelengt

Engineering drawing, connect two given points A and B by a parabolic curve ...

connect two given points A and B by a parabolic curve when OA=60mm,OB=80mm and angle AOB=110 degree

Microwaves, derive the s parameters of a network by smith chart

derive the s parameters of a network by smith chart

Calculate the magnitude of fault current, Figure shows an isolated three-ph...

Figure shows an isolated three-phase load supplied from a 33 kV/11 kV substation via a 30 km long three-phase 11 kV overhead line. The overhead line has the following series parame

Congestion, It is uneconomic to provide adequate equipment to carry all the...

It is uneconomic to provide adequate equipment to carry all the traffic which could possibly be offered to a telecommunication system. In a telephone exchange it's theoretically po

Safe conduct in electricity and gas hazards, Safe Conduct : what if a tr...

Safe Conduct : what if a trailing flex became caught up in an apparatus trolley and was cut? Or someone splashed water onto a plug, or concentrated sulphuric acid onto a flex? F

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd