Define lateral load - actions in pot bearings, Civil Engineering

Assignment Help:

Define Lateral Load - Actions in POT Bearings?

Lateral load is transferred from the piston to the POT by contact between the rim of the piston and the wall of the POT. The contact stresses are generally very high. Lateral loads may also contribute to increased wear of the elastomeric pads and greater potential for wear and fracture of the sealing rings. The damage observed in tests suggests that the lateral load should be carried through an independent mechanism wherever possible.


Related Discussions:- Define lateral load - actions in pot bearings

Compass survey, define compass survey and mention its objectives

define compass survey and mention its objectives

What is gravity flow, Gravity flow is fluid flowing because of the forces o...

Gravity flow is fluid flowing because of the forces of gravity alone and not to an applied pressure head. In the Bernoulli equation, the pressure term is omitted, and the height an

Traditional granular sub-base, Question For rigid pavement, what is rec...

Question For rigid pavement, what is recompense of using lean concrete sub-base instead of traditional granular sub-base? Answer There are some shortcomings of using

Interface between base plates and footings, Interface between base plates a...

Interface between base plates and footings Surface of footings is generally quite rough so that some levelling has to be carried out for base plates. Interface between base pl

Determine the cost of compensation, The soil in a borrow pit has a void rat...

The soil in a borrow pit has a void ratio of 0.90. A fill-in-place volume of 20,000 m 3 is to be constructed with an in-place dry density of 18.84 kN/m 3 . If the owner of borr

Why nautical mile is different from statute mile, One nautical mile is desc...

One nautical mile is described by one latitude minute of arc (there are 60 like minutes to a degree). This equals 1852 meters, and roughly (but coincidentally) 2000 yards or 6000 f

Beams, how to convert uniformly varying loads to point loads

how to convert uniformly varying loads to point loads

Indicate quality of rock foundation, Question During piling works, norm...

Question During piling works, normally founding levels of bored piles are definite by using total core recovery or rock quality designation (RQD). Are there any problems by

BRIDGES, WHAT ARE THE DIFFERENT TYPES OF BRIDGES

WHAT ARE THE DIFFERENT TYPES OF BRIDGES

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd