Default cdp broadcast update rate for cisco routers, Computer Networking

Assignment Help:

What is the default CDP broadcast update rate for Cisco routers?

Ans) Cisco Discovery Protocol is a proprietary protocol to permit you to access configuration information on other routers and switches with a one command. It uses SNAP at the Data-Link Layer. By default CDP sends out a broadcast each 60 seconds and it holds this information for 180 seconds. CDP is enabled by default.

Related Discussions:- Default cdp broadcast update rate for cisco routers

Inductor, #clasification of inductor

#clasification of inductor

Application to exploring network packet capture, This lab introduces basic ...

This lab introduces basic network capture concepts using Wireshark. Setup You will need a PC running Windows for this lab and you will need to install the Wireshark softwar

Write the command to reload the router, Router# reload is the command to r...

Router# reload is the command to reload the router

Delivering message through lan, Delivering message through LAN: We hav...

Delivering message through LAN: We have to devise method for delivering message through LAN phase to single, specific destination device. Sending device uses a hardware addres

Illustrate the drawbacks of stop and wait, Q. Illustrate the Drawbacks of s...

Q. Illustrate the Drawbacks of stop and wait? Drawbacks of stop and wait - Only one frame is able to be in transit at a time - After every frame sent the host must wai

Firewalls - point to point, Firewalls After several security related ...

Firewalls After several security related internet newsgroups started overflowing with posts it becomes clear something hand to done to help secure networks. The first

Advantages of ls over dv algorithm, Advantages of LS over DV algorithm ...

Advantages of LS over DV algorithm There are a number of advantages to link state protocols especially when compared to the distance vector based routing protocols. The

Synchronization in factor causing , Synchronization Multiple processors...

Synchronization Multiple processors need synchronization with each other while implementing a parallel algorithm. That is, the task running on processor X might have to wait fo

Failure reporting and analysis, 1. A systematic study of failures will help...

1. A systematic study of failures will help in identifying areas that may cause : i. Loss of adjacent parts/ equipment/ whole equipment. ii. Loss of production and rev

Enumerate about the traffic policing, Enumerate about the Traffic policing ...

Enumerate about the Traffic policing Traffic policing happens when a flow of data is regulated so that cells (or frames or packets) that exceed a performance level are discarde

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages