Corrosion control in oil-treating equipment, Mechanical Engineering

Assignment Help:

Q. Corrosion Control in Oil-Treating Equipment?

Bitumen provides adequate internal protection for Inlet Slug Catcher, FWKO and Treater. Due to high operating temperature, internal coating is not normally recommended. Also CP system will not perform well due to the bitumen layer that may form on the anode surface.

Over time, water may collect in the bottom of Diluent Tank, Dilbit Tank and Off Spec Storage Tank. Internal coating is a mandatory requirement for floor and lowest 1 meter of shell.


Related Discussions:- Corrosion control in oil-treating equipment

Evaluate the chebyshev spacing for a function, Evaluate the chebyshev Spaci...

Evaluate the chebyshev Spacing for a function y = 2 x 2 - x for the range 0 ≤ x ≤ 2 where four precision point are required. For these precision points, determine φ 2 , φ 3 , φ 4

Lead acid battery -electrical system , Lead Acid Battery :  The lead acid ...

Lead Acid Battery :  The lead acid type of battery is generally used in all types of two wheelers. It consists of six cells and the rating of the battery is 12 V-2.5 Ah and 12 V-5

Compute the deflection and maximum bending stress, For the beam shown in Fi...

For the beam shown in Figure compute the deflection at the element nodes. The modulus of elasticity is psi and the cross section is as shown in the figure. Also compute the maximum

Door strap pull force, A pull up door is stuck in the closed position. A st...

A pull up door is stuck in the closed position. A strap, fastened on the inside bottom and located at the center of the door is pulled outward at an angle of 45 deg above horizonta

Illustrate critical damping, Illustrate any three of the following : (i)...

Illustrate any three of the following : (i) Critical Damping (ii) Logarithmic decrement (iii) Vibration Isolation (iv) Equivalent stiffness of spring in series and in p

Calculate the angle of heel, a) Derive a mathematical expression for stabil...

a) Derive a mathematical expression for stability of an automobile while accelarating in a curved path? b) A motorcycle and its rider together have a mass of 250Kg and their cen

Lean mixture -mixture requirement , Lean Mixture: It generally ranges...

Lean Mixture: It generally ranges from approximately 15 : 1 to 17 : 1. By the use of this fuel, engine runs for higher economy.

Construct a plain scale, Construct a plain scale: The distance between...

Construct a plain scale: The distance between Indore and Bhopal is 180 kilometer. It is represented on the map via 9 centimeter. Construct a plain scale for such map, illustra

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd