Condition return, Electrical Engineering

Assignment Help:

Condition Return

Similar to conditional jump and call  instructions there are conditional return  instructions  also  based on various  flags.

 

 


Related Discussions:- Condition return

Explain working of biased clamper, Q. Explain working of Biased Clamper? ...

Q. Explain working of Biased Clamper? Biased Clamper : The circuit of a positively biased clamper is shown in the figure. During the negative half cycle of the input signal the

What are hard magnetic materials, What are hard magnetic materials? Har...

What are hard magnetic materials? Hard Magnetic materials- They have a slowly rising magnetization curve along with large hysteresis loop area and therefore large energy losses

Clampers, just to put an assignment Give only short details that are impor...

just to put an assignment Give only short details that are important Specially bised clamper

Evaluate the thickness of the shell plate, A cylindrical shell with flat en...

A cylindrical shell with flat ends is of 1.5 m Internal diameter and 4 m length. It is subjected to an internal pressure of 300 N/cm 2 . The principal stress is not to exceed 15 K

Determine the magnitude of the current, Determine the magnitude of the curr...

Determine the magnitude of the current: For the circuit of Figure below determine the magnitude of the voltage "drops" across each resistor R1 - R7. Determine the magnitude

Determine the input current and input voltage, Q. A 100-kVA, 2300:230-V, 60...

Q. A 100-kVA, 2300:230-V, 60-Hz, single-phase transformer has the following parameters: R 1 = 0.30 , R 2 = 0.003 , RC 1 = 4.5k, X 1 = 0.65 , X 2 = 0.0065 , and Xm 1 = 1.

Calculate total internal resistance, One battery having of four cells, conn...

One battery having of four cells, connected in series. Emf of each cell is 1.45V and internal resistance of 0.04Ω. if a load resistance of 5Ω is connected to the battery, draw the

Required conditions for connecting two transformers, Q. Required Conditions...

Q. Required Conditions for connecting two transformers in parallel? Ans: a) Voltage rating should be same b) Per unit impedance should be same c) Phase sequence should

Use of n-channel jfet, Q. Use of N-channel JFET? Generally, N-channel J...

Q. Use of N-channel JFET? Generally, N-channel JFETs are more commonly used than P-channel. With no voltage applied between gate and source, the channel is a wide-open path for

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd