Determine frequency of rotor current, A 3 phase, 6 pole induction motor is ...

A 3 phase, 6 pole induction motor is rated at 400hz, 150v, 10h.p., 3% slip at rated power output. The windage and friction loss is 200w at rated speed. With the motor operating at

Estimate the length of the wire required to get a resistance, A heater elem...

A heater element is made of nichrome wire having resistivity equal to 100 × 10 -8 ohm-m. The diameter of the wire is 0.4mm. Calculate the length of the wire required to get a resi

Pnp transistor operation, how does it work explain with figure?

how does it work explain with figure?

Vital parameters of regulator quality, Vital parameters of regulator qualit...

Vital parameters of regulator quality: 1. The output voltage's temperature coefficient of is the change in output voltage with temperature (perhaps averaged over a certain tem

Explain the test instruction, Explain the TEST instruction. TEST: The T...

Explain the TEST instruction. TEST: The TEST instruction executes the AND operation. The difference is as the AND instruction changes the destination operand, whereas the TEST

#titl4 bit binary addere.., Ask question #Madvantages of 4 bit binary adder...

Ask question #Madvantages of 4 bit binary adder inimum 100 words accepted#

3-phase 3 wire meter with ct and md, 3-phase 3 wire meter with CT and MD ...

3-phase 3 wire meter with CT and MD It is exactly such as 3-phase 4 wire meter and works on the similar principle. It is also used in the similar way and under the similar cir

\, Refer to Figure 100. Assume MKS units. Given: R1= 4, R2=14, R3= 9, I4...

Refer to Figure 100. Assume MKS units. Given: R1= 4, R2=14, R3= 9, I4= 8, I5= 7. Determine: Ieq, Req, and V3.

Microprofessor,

Speed control of dc motor using pid, The objective of the project is to pro...

The objective of the project is to protect damage of the DC motors. If the motor is not working it will be shown with red light, if working normally then green and if working at a