Briefly describe nat and rip, Computer Networking

Assignment Help:

Briefly describe NAT and RIP

NAT is Network Address Translation. This is a protocol that gives a way for multiple computers on a common network to share one connection to the Internet.

RIP stands for Routing Information Protocol is used by routers to send data from one network to another. It well manages routing data by broadcasting its routing table to all other routers within the network. It verifies the network distance in units of hops.

 


Related Discussions:- Briefly describe nat and rip

What is frequency diversity, What is Frequency diversity Due to the tra...

What is Frequency diversity Due to the transmission is spread out over a larger bandwidth, frequency-dependent transmission impairments, like as noise bursts and selective fadi

What is sockets, A socket is an abstraction that shows an endpoint of commu...

A socket is an abstraction that shows an endpoint of communication. Most applications that consciously use TCP and UDP do so by making a socket of the appropriate type and then per

Network Fundamentals BTech Telecommunication, Write a report on your chosen...

Write a report on your chosen topic that has been approved by your Lecturer. Your report should include appropriate figures, about 2000 words. Topics: 1 MAN- Metro Ethernet 2 Inte

Tcp, how tcp is redefined for wireless network

how tcp is redefined for wireless network

Telecoms, What is a Multiplexor

What is a Multiplexor

What is tdm, What is TDM? TDM is a digital process that can be applied ...

What is TDM? TDM is a digital process that can be applied when the data rate capacity of the transmission medium is greater than the data rate needed by the sending and receivi

How two adjacent layers communicate in a layered network, How two adjacent ...

How two adjacent layers communicate in a layered network? (or What do you mean by Service Access Point?) In layered network, each layer has lots of entities and entities of lay

How to perform basic switch configurations-ccna, How to Perform Basic Switc...

How to Perform Basic Switch Configurations Step : Complete basic configuration of switches S1, S2, and S3. Configure the S1, S2, and S3 switches according to the following

State the characteristics of thinnet, Thinnet Characteristics Short...

Thinnet Characteristics Shorter range (185 meters) as well as smaller capacity Bus topology LAN Connectors and cables include: thin coaxial cable, NICs and BNC-T

Explain in brief about crc, What is CRC The CRC is computed while trans...

What is CRC The CRC is computed while transmission and appended to output stream as soon as last bit goes out onto wire. If the CRC were in header, it will be necessary to make

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd