Annotation with leaders, Mechanical Engineering

Assignment Help:

Annotation with Leaders

Ordinate dimensions are not really an dimensions at all in that they do not indicate a measurement.They annotate known as a co-ordinate points. The DIMORDINATE command is used to be indicate the X and Y ordinate values at any point.

 


Related Discussions:- Annotation with leaders

Electron beam welding(ebw)-basic principle, BASIC PRINCIPLE OF ELECTRON BEA...

BASIC PRINCIPLE OF ELECTRON BEAM WELDING(EBW)   Electron beam welding which utilises a heat source of electrons which are accelerated by an electric field to mextremely high

Fault detection and isolation for lateral flight of an uav, Introduction   ...

Introduction   Fault tolerance is very important for aircraft flight control.  The majority of the faults occur in the sensors and actuators onboard the aircraft.  Once a fault

Find out change in diameter, Find out change in diameter: A cylindrica...

Find out change in diameter: A cylindrical shell, 0.8 m in a diameter and 3 m long is along with 10 mm wall thickness. If the shell is subjected into an internal pressure of 2

Material handling equipment, In selection of material handling equipment...

In selection of material handling equipment itself Hageman indicates that the final consideration are: 1. Methods of Installation: Operating controls should be accessibl

Design the drainage area, Q. Design the drainage area? Areas beneath eq...

Q. Design the drainage area? Areas beneath equipment or vessels subject to spills or leaks shall have slope drainage area. Every skid shall be provided with floor drains. S

I-Section, An unsymmetrical I-Section as shown in figure below. If maximum ...

An unsymmetrical I-Section as shown in figure below. If maximum bending stress is not extend more than 40MPa in the section than find out the moment which it can bear

Plate shift drum stopper bolt and arm comp, Plate shift drum stopper bolt a...

Plate shift drum stopper bolt and arm comp Shift drum stopper : Ensure that the plate shift drum bolt is tight and in arm shift drum stopper assembly, check stopper arm bolt for to

Calculate the crack stress intensity factor, Calculate the crack Stress Int...

Calculate the crack Stress Intensity Factor: If on the beam specimen of last problem two loads, each equal to 500 N, are applied at distance of 25 mm from central plane, calcu

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd