5 igrp supports a feature , Computer Networking

Assignment Help:

5 IGRP supports a feature that permits traffic to be distributed among up to 6 (4 default) paths to give greater allover throughput and reliability. What is this called?

Ans) An unequal-cost load balancing is used to give alternate paths for data distribution on an internetwork. Cisco developed this method to use unused or underutilized links to enhance bandwidth and network availability.  

 


Related Discussions:- 5 igrp supports a feature

Time out - transport layer, Time  out Timers  are used to protect  aga...

Time  out Timers  are used to protect  against  lost packet. Each  packet  must have its own logical  timers since  only  a single  packet  will be retransmitted  after timeou

What is proxy serer and firewall, What is Proxy Sever and Firewall Pro...

What is Proxy Sever and Firewall Proxy Sever Also known as a proxy or application level gateway. It is an application that breaks the connection among sender and receiver.

Distributed data processing, In distributed data processing, explain two sc...

In distributed data processing, explain two scenarios where vertical partitioning and horizontal partitioning are used. Distributed Data Processing The distributed data pro

Message passing programming, Message passing is probably the most extensive...

Message passing is probably the most extensively used parallel programming paradigm today. It is the mainly natural, portable and efficient approach for distributed memory systems.

What rate rtcp will limit, Consider an RTP session consisting of five users...

Consider an RTP session consisting of five users, all of which are sending and receiving RTP packets into the same multicast address. Each user sends video at 200kbps. a)  What

Processor arrangements-array, Processor Arrangements It is a very frequ...

Processor Arrangements It is a very frequent event in data parallel programming to group a number of processors to perform definite tasks. To reach this goal, HPF gives a direc

Calculate the peak-to-peak voltage of the signal, A multimeter is used to m...

A multimeter is used to measure a sinusoidal signal and reads 2V RMS; what is the peak-to-peak voltage of the signal? A mark will be deducted if you do not quote your answer to 2 s

Use of a distance vector routing algorithm, Question: (a) The diagram ...

Question: (a) The diagram below shows a configuration of Internet routers (A-F) which achieve dynamic routing through the use of a Distance Vector routing algorithm. The metr

Explain in detail about wireless network, Explain in detail about wireless ...

Explain in detail about wireless network Think about unseen terminal problem. Imagine a wireless network consist of five stations, A through E, such that each one them is in r

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd