How do you find the insulation resistance of transformer, Q. How do you cal...

Q. How do you calculate the insulation resistance of transformer and what is the minimum value? Ans. The insulation resistance of the transformer will be calculated by using

What is meant by a bus, A bus is a collection of conducting lines that carr...

A bus is a collection of conducting lines that carrier's data, address, & control signals. A bus is two or many wire communication technique. A bus which communicate among two

Explain light-emitting diode, Q. Explain Light-emitting diode? This is ...

Q. Explain Light-emitting diode? This is a reliable, rugged, and inexpensive semiconductor display device requiring about 10 mA of current flow for full illumination. An LED is

Microprofessor,

Radio hardware, Filters 1. You need to design a lowpass filter with cutoff ...

Filters 1. You need to design a lowpass filter with cutoff frequency Fc= 1MHz. a. What is the minimum filter order required for 30 dB rejection (-30 dB gain) of 10 MHz? b. What is

find the value of the slip and air gap power, The Thevenin equivalent circ...

The Thevenin equivalent circuit at the terminals of R2 / S for a 60 hz, 6 pole induction motor is shown below. a) Find the value of the slip for maximum torque and the maximum t

Magnetic ckt''s, what is the difference between statically and dynamically ...

what is the difference between statically and dynamically induced emf''s

Draw the re-model for the circuit, Draw the re-model for the circuit given ...

Draw the re-model for the circuit given in figure and calculate: a). The input impedance (β=100), b). The output impedance (r0 = 50 kΩ) and c). The mid-band collector-base

Customer satisfaction - issues of power supply, Customer Satisfaction - Iss...

Customer Satisfaction - Issues of Power Supply Customer satisfaction measurement is a systematic process for collecting customer data (e.g. surveys, audits and etc.), analyzin

Determine the node voltage, Determine the node voltage: Determine the ...

Determine the node voltage: Determine the node voltage V and then current flowing through each element by using KCL. Solution Apply KCL at the node whose voltage is V.