compound belt drive, Mechanical Engineering

Assignment Help:

Compound Belt Drive:

When several pulleys are used to transmit power from one shaft to the other then a compound belt drive can be obtained.

1350_open belt drive3.png

Figure

Velocity Ratio for Compound Belt Drive

1146_open belt drive4.png

N4/N1  = (D1.D3)/(D2.D4)

 


Related Discussions:- compound belt drive

Determine the elements of the vdafs version 2.0, Determine the Elements of ...

Determine the Elements of the VDAFS version 2.0 Elements of the VDAFS version 2.0 are shown in Table. Curves and surfaces are described with the help of points, set of points

Resource holon, Normal 0 false false false EN-US X-NO...

Normal 0 false false false EN-US X-NONE X-NONE

Explain the creation phase of paver machine, Creation phase of Paver machin...

Creation phase of Paver machine: Objective: "To generate alternative methods for providing the function, through creative thinking, brainstorming and even speculation."

Rough-cut capacity planning, A small producer of specialist vehicles is bui...

A small producer of specialist vehicles is building a new workshop to meet expected demand for its products over a period of 5 years.  The workshop will contain three workcentres,

Determine the ratio of the inlet pipe diameter, Air flows steadily at the r...

Air flows steadily at the rate of 0.5 kg/s through an air compressor, entering at 7m/s velocity, 100 kPa pressure, and 0.95 m 3 /kg volume, and leaving at 5 m/s, 700 kPa, and 0.19

Determine the loss in fuel cost per hour, Give a neat and clean diagram of ...

Give a neat and clean diagram of Heavy water type "CANDU" nuclear power plant and illustrate its working. The incremental fuel costs for two generating units ‘a and b' of a powe

Calculate all the mass-normalised modal vectors, The body, suspension and e...

The body, suspension and engine mounting system of a vehicle may be idealised as a three degree of freedom system consisting of a bar of mass 1400 kg and the centre of mass at G, 1

What is mock-up testing, Q. What is Mock-up Testing? Tube to all tubesh...

Q. What is Mock-up Testing? Tube to all tubesheet weld tests shall be provided as described below. Mock-up of 10 tubes about 305 mm (12") long are welded to a portion of a t

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd