components in the following command ''interface serial0/1/1'', Computer Networking

Assignment Help:

Recognize the components in the following command 'interface serial0/1/1'

Ans) Serial interface, slot 0, port adapter 1, port number 1

Related Discussions:- components in the following command ''interface serial0/1/1''

Determine the subnet with subnet prefix, Consider a subnet with subnet pref...

Consider a subnet with subnet prefix 101.101.101/24 a) If you subdivide the subnet into four equal size subnets, what are their prefixes? Give all four prefixes in the form a.

Factor causing parallel overheads, Factor Causing Parallel Overheads F...

Factor Causing Parallel Overheads Figure clearly explains that the performance metrics are not able to achieve a linear curve in comparison to the enhance in number of process

Error detection-general, Q. Error Detection-General? Sender transmi...

Q. Error Detection-General? Sender transmits every data unit twice Receiver performs bit-by-bit comparison between those two versions of data. Any mismatch would

Explain use of perimeter area, Explain use of perimeter area?

Explain use of perimeter area?

Define metropolitan area network, Q. Define Metropolitan Area Network? ...

Q. Define Metropolitan Area Network? Metropolitan Area Network (MAN) Cable Network Architecture: Overview Protocols and Standards - Set of regulations that go

What are called fat clients and fat servers, If the amount of the applicati...

If the amount of the application runs on the Client side, then it is Fat clients. It is mostly used for decision support and personal software. If the amount of the application

Name the categories of multiplexing, Name the categories of Multiplexing? ...

Name the categories of Multiplexing? There are three categories of multiplexing a. Frequency Division Multiplexing (FDM) b. Time Division Multiplexing (TDM) i. Sync

Difference between trigger and rule, What is the difference between trigger...

What is the difference between trigger and rule? Ans) The triggers are known as implicitly by database generated events, whereas stored procedures are known as explicitly by cli

Define bandwidth and latency, Define Bandwidth and Latency? Network per...

Define Bandwidth and Latency? Network performance is calculated in Bandwidth (throughput) and Latency (Delay). Bandwidth of a network is given by the number of bits that can be

Measurement on latency and bandwidth , Measure the performance (both latenc...

Measure the performance (both latency and throughput) of TCP and UDP protocol stack running on a pair of PCs or Workstations in the Lab, and compare the results of your software

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages