Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Write the theoretical Power Spectral Density for a BPSK signal with shift angle of 180 degrees, carrier of 25 kHz and bit rate of about 1 kHz that has been spread by a PN sequence with a bit rate of about 100 kHz. State it or derive it. Provide clear definitions of the variables and a reference for your starting point.
Consider the collision between two hockey pucks in the figure below. They do not stick together. Their speeds before the collision are v1i = 26 m/s and v2i = 11 m/s. It is found that after the collision one of the pucks is moving along x with a sp..
A 3-phase, 2300 V, 60 Hz, 12-pole, Y-connected synchronous motor has 4.5 ? per phase synchronous reactance and negligible stator winding resistance. The motor is connected to an infinite bus and draws 250 A at 0.8 power factor lagging.
Three 150 kVA, 480V/4000V,60 Hz single-phase transformers are to be installed on a 4000V, 3-phase line. The exciting current has a value of 0.02 pu. Calculate the line current when the transformers are operating at no-load.
Design a circuit that will calculate the value for the average voltage for three input signals. Draw the circuit schematic identifying supply voltages and show your work on component selection.
A controlled three-phase six-pulse AC/DC converter is supplied with 60 Hz voltage of the line-to-ground RMS value U = 240 V with the output current ideally filtered by an inductor. The maximum DC power of the converter (Pd)max = 50 kW.
Two rectangular waveguides, one air filled with internal dimensions 2cm x 1cm and the other dielectric filled with internal dimensions 1cm x 0.5cm, have the same cut-off frequency for the dominant mode. what is The relative permittivity of the die..
Write an asm HCS12 program to flash LEDs on a dragon+ board three times when SW5 is pressed with a 5 kHz frequency, and 50% duty cycle clock signal. Generate a clock signal with 5 kHz frequency, and 50% duty cycle.
A conductor 1 cm long is oriented parallel to the z axis a distance r = 25 cm from the origin and rotates at a speed of 1200 revolutions / minute. Find the voltage induced in the conductor if the driver rotates
An amplifier with 40 dB of small-signal, open circuit voltage gain, an input resistance of 1M Ohm, and an output resistance of 10 Ohm, drives a load of 100 Ohm. What voltage and power gains (in dB) would you expect with the load connected
A Widlar Current Source is designed to limit the load current to the reference current by using a resistor at the emitter end by:I(load)*R(Emitter)=Vt ln (I(ref)/I(load))=VBE(Ref)-VBE(Load)
Consequently, this form of serial data communication is known as asynchronous. Compare and contrast this against synchronous serial data communication, giving an example of a synchronous data communications standard.
Description of Transformer, An 11 kV to 415 V transformer has a rating of 100 kVA. The winding resistance and leakage reactance when referred to the secondary are 0.0142 Ohm and 0.0569 Ohm respectively
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd