Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Given transfer function of dynamic system: T(s)= (2s^2 + 2s + 3) / (s^3 + 4s^2 + 6s + 10). write down state equation and output equation in Controllable Canonical Form and in Observable Canonical Form.
When unmodulated the carrier voltage is 75 volts peak. An information (modulating) signal of 15 KHZ with 5 volts peak amplitude causes a frequency deviation of 22.5 KHz. If the load resistor RL= 100 Ohms, determine the following Modulation index
Students should type up, assemble and emulate the BIN2ASCII program which converts the value entered in R3 from Hexadecimal to ASCII. This should be done by dividing R3 by 10 (decimal) and converting the remainder to ASCII
Need for radical future plans to alleviate the very real problem we are faced with in New Zealand and address this problem, by providing an answer to Transpower
Given that the number of charges measured at t1 is n1 = 2.20×10^19, and the number of charges measured at t2 is n2 = 7.15×10^19. Find the current flow if the time interval between t1 and t2 is 2 s.
The controlled variable in a closed-loop system is the direction of a robot arm. Initially, it is at 50o; then it is commanded to go to 25o. What is the error when the arm position is at 15o
A HCS12 ATD is set to 10-bit unsigned mode. The voltage references are set to ground and 1.0V What is the ADT output for a temperature of 81 degrees The temperature sensor measures 0 to 100 degrees with an output of 10 mV/degree.
Discuss different types of addressing modes of HCS12. What is a relative addressing mode What is the difference between a direct and an extended addressing mode Discuss how Registers X and Y are used in index addressing mode.
Let a series R-L-C network be connected to a source voltage V, drawing a current I. a) In terms of the load impedance Z=Z at angle of Z, find expressions for P and Q from complex power considerations.
If we want to correct the power factor to 0.9 lagging, what is the value of Q we need to inject.
A combination of silver/silver chloride and cadmium electrodes are used for biomedical application. a.) Estimate the half-cell potentials of each of the electrodes assuming the potentials don't change between 25deg and body temp.
1) Determine the transfer of second-order highpass filter with a cutoff frequency of 900 Hz and passband gain of 1 using a butterworth type. 2) Design a filter for your transfer function using the sallen-Key topology.Find all the values of the circ..
However, for short-time operation, a delta connection can be used at the nominal wye voltage. Find the ratio between the power delivered to the same motor in the wye and delta connections.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd