Write and test a c program that outputs a waveform

Assignment Help Electrical Engineering
Reference no: EM13230272

Write and test a C program that outputs a waveform that switches from 10.0 kHz with a 50% duty cycle to 25.0 kHz with a 5% duty cycle every 5 seconds. Your code design must be modular - initializations and program operations are to be performed by calling functions.

Reference no: EM13230272

Questions Cloud

Discuss benefits of working with shell scripts : Discuss the benefits and provide examples of working with shell scripts.
Explain how this affect the subsequent bid : Supposed there was a significant delag between the contracts. During this time, personnel and equipment were reassigned to other projects. Explain how this affect the subsequent bid?
Determine the ph also all of the equilibrium concentrations : Determine the pH, percent ionization and all of the equilibrium concentrations for each of the following.
What disadvantages does the court system have : Advise BDM as to its legal rights against AWB under Clause 4 of their contract and what disadvantages does the court system have as a system for resolving disputes between the parties to a commercial contract?
Write and test a c program that outputs a waveform : Write and test a C program that outputs a waveform that switches from 10.0 kHz with a 50% duty cycle to 25.0 kHz with a 5% duty cycle every 5 seconds. Your code design must be modular - initializations and program operations are to be performed
What would be the expected time : A time standard was set as 0.20 hour per unit based on the 50th unit produced. If the task has a 90 percent learning curve, what would be the expected time of the 100th, 200th, and 400th units? Show work
Prepare a direct labor budget for the upcoming year : Prepare a direct labor budget for the upcoming year that shows the budgeted direct labor cost for each department and for the company as a whole.
What is the velocity of propagation in the cable : A certain transmission line is 10 meters long. Measurements indicate that the total inductance of the cable is 16 H. Standing wave measurements indicate that the voltage reflection coefficient at the load is 0.5 + j0 when a 75 ohm resistor
Describe and contrast the rights of bond holders : Describe and contrast the rights of bond holders and preferred stockholders. Which has the best position in a default, which one would you buy all other things being equal.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Draw block diagram of a communication channel

Explain the characteristics of electromagnetic waves and application to communications systems and determine the signal spectra for the content of complex waveforms

  How far does the sled go before stopping

A sled is traveling at 4 m/s along a horizontal stretch of snow. The coefficient of kinetic friction is 0.05 . How far does the sled go before stopping ?

  What resistance must be connected in series with heater rate

What resistance must be connected in series with a heater rated at 150mA with hot resistance of 320 ohm in order to operate it safely from a 117-V source. What power rating must this resistor have

  Explain current and average power delivered to the load

Current and average power delivered to the load, A load has a 20 ohm resistor and a 4 henry inductor connected in series. It is connected to a power source with v(t)= 100cos50t

  Determine the uncorrected poer factor and reactive load

A 2.4KV, single-phase circuit suppllies a load of 250KW at a lagging power factor, and the load current is 160A. If it is necessary to improve the power factor, determine the following: (a)The uncorrected poer factor and reactive load.

  Write the ybus matrix

Identify the bus types and the unknown variables of the power flow problem. Write the complete set of equations needed to solve the load flow problem.

  Estimate the starting concentration of impurity

A limited source diffusion is used to define the base of an npn transistor. Estimate the starting concentration of impurity if the base-collector junction lies 1micro-meter below the surface after 2h diffusion at 1100 degrees C.

  Determine an equation for angular velocity

If the battery is replaced with a 6 Volt battery it was experimentally determine that the no load speed is reduced to 120 rpm. For this situation, determine a new equation for angular velocity,(in rad/sec) versus Torque (in Nm).

  What is the average velocity of an electron

If the concentration of free electrons is 10^29 electrons per cubic meter and if they are uniformly dispersed throught the wire, then what is the average velocity of an electron ?

  Performance analysis of 16 bit by16 bit mac design

Performance Analysis of 16 Bit by16 Bit MAC design using 5:3 Compressors - 3:2 counters and 4:2 compressors have been widely used for multiplier implementations.

  How far away can the cars radar detector receiver detect

A police K-band radar is operating, with transmit power of 1000 Watts and antenna gain of 300 in linear units. The radar unit is designed to detect a target with a radar cross-section (RCS) of 6 sq. meters and its receiver can detect a signal

  What makes base 16 an attractive numbering system

1.Convert 5EDA into binary number. What makes base 16 (Hexadecimal) an attractive numbering systems for representing values in computers 2. What is 4365 - 3412 when these values represent unsigned 12-bit octal numbers

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd