Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
There are two arrays "arr1" and "arr2," each with three bytes of data. Write an assembly language code segment to swap the contents of the two arrays. For example if arr1 and arr2 initially contain characters "abc" and "123" respectively, then after executing the code, they should contain "123" and "abc" respectively.
Using your knowledge of ‘State Machine' design from logic design principles, draw the state diagram for the 2-bit down-counter, generate the state transition table, the flip-flip input equations for D Flip Flop, and finally the logic diagram of th..
Compute the polar form of the impedances shown below in rectangular form in parts a and b, and compute the rectangular form of the impedances shown below in polar form in parts c and d
A 60 Hz, three-phase, transposed transmission line has the following parameters: Z = 13.114+ j52.952, Y = j0.311/1000. The sending-end line-to-line voltage is 161 kV. The total receiving-end load is represented by ZL =143 with an angle
The generator is delivering 48 MW to the bus bar at the rated voltage with its field current adjusted for a generated emf of 46 kV per phase. Determine the armature current and the power factor. State whether power factor is lagging or leading
A 60-Hz, 220-V-rms source supplies power to a load consisting of a resistance in series with a capacitance. The real power is 2000W, and the apparent power is 2500VA. Determine the value of the resistance and the value of the capacitance.
The transmission line has an impedance of 600 ohms and is terminated in a load of 600 ohms. The transmitter delivers an average power of 0.1 W to the input of the line.
The voltage drops across three resistors in series are measured 10V, 15V, and 25V. If the largest resistor is 47 ohms, what is the value of the smallest resistor?
What is the frequency of the rotor currents? What is the angular velocity of the stator field with respect to the stator? With respect to the rotor?
(a) Design a simple PNP current source to give an output current of IO = 0.5 mA (nominal value). The transistor parameters are f = 50, VEE = 10 V, VCC = 10V, |VBE| = 0.7 V, |VCEsat| = 0.3 V and VA = 50 V (for all transistors)
Assuming that the energy gap does not change with temperature, calculate the intrinsic electron concentration at the two temperatures. Look up the data for silicon that you need. Give your answer in carriers per cm cubed.
plane polarized light is sent through two consecutive polarizers, the first having its plane of polarization in the same direction as the incident light and the second having its palne at 90 degrees to the original plane of polarization.
a critically damped parallel rlc circuit is constructed from component valures 40Ω, 8nF, and 51.2μH, respectively. verify that the circuit is indeed critically damped and then explain why the circuit once fabricated is unlikely to be trruely criti..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd