Reference no: EM132080188

You need help writing a code for an arduino and servo motor. You need the servo motor to rotate 180* after pressing a button on Your laptop and then You need the servo motor to go back to 0* after pressing a button on my laptop again.

You found this code but it doesn't work and You don't think it goes from 180* to 0* on command.

int pos = 0; // variable to store the servo position
void setup() {
myservo.attach(9); // attaches the servo on pin 9 to the servo object
}
void loop() {
for (pos = 0; pos <= 180; pos += 1) { // goes from 0 degrees to 180 degrees
// in steps of 1 degree
myservo.write(pos); // tell servo to go to position in variable 'pos'
delay(15); // waits 15ms for the servo to reach the position
}
for (pos = 180; pos >= 0; pos -= 1) { // goes from 180 degrees to 0 degrees
myservo.write(pos); // tell servo to go to position in variable 'pos'
delay(15); // waits 15ms for the servo to reach the position
}
}