With the equipment provided in labs why do you observe only

Assignment Help Physics

Reference no: EM13625418

With the equipment provided in labs why do you observe only the Balmer series, but not the Lyman or Paschen series?

a) The equipment is limited and the intensity of the lines from the other series is too low for them to be observed.

b) There is no real difference between the Balmer, Lyman, and Paschen series. You have to have a specially manufactured tube to see each one.

c) Four orbital transitions in the Balmer series are in the visible range, none in the other series are.

d) An electron microscope is required to see the other series.

e) The Balmer series is the only one that gives off energy.

f) The Balmer series spectrum is in the visible range, the others are ultrasonic.

Reference no: EM13625418

Questions Cloud

Which is that hardness is measured as the applied load : one of the inspectors in the quality control department has frequently used the brinell and rockwell hardness tests for

Driving a 2000-ft loaded horizontal conveyor at 4 fts : driving a 2000-ft loaded horizontal conveyor at 4 fts requires 35hp. what horsepower would be required if the conveyor

Wwhat is the anticipated load at which the speciment is : a bending test is used on an experimental cemented carbide material. based on previous testing of the material its

The flow curve for austenitic stainless steel has the : the flow curve for austenitic stainless steel has the following parameters strength coefficient 1200 mpa and

With the equipment provided in labs why do you observe only : with the equipment provided in labs why do you observe only the balmer series but not the lyman or paschen series?a the

A piping system consists of 100 ft of 2-in pipe a sudden : a piping system consists of 100 ft of 2-in pipe a sudden expansion to 3-in pipe and then 50 ft of 3-in pipe. water is

A copper wire of diameter 080 mm fails at an engineering : a copper wire of diameter 0.80 mm fails at an engineering stress 248.2 mpa. its ductility is measured as 75 reduction

Determine the yield strength modulus of elasticity tensile : in a tensile test the starting gage length 100 mm and the cross-sectional area 150 mm2. during testing the following

Water flows straight down from an open faucet the : water flows straight down from an open faucet. the cross-sectional area of the faucet is 1.2 times 10-4m2 and the speed

User Account

All Pages